INSTALLATION REQUIREMENTS
Tools and Parts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
SMART-MOUNT® tray assembly installation
A 
B 
Tools needed
■
■¹⁄₄" nut driver
■⁷⁄₁₆" wrench
■Scissors
■Pencil
■Tape measure
■Level
■Drill
■³⁄₃₂" or smaller drill bit
C
D
Through-the-Wall Installation
In addition to the tools listed above, the following tools are needed for
■ | Saw | ■ | Caulk |
■ | Wood preservative | ■ | 1" (2.5 cm) or thicker |
|
|
| lumber |
E | F | G | H I | J |
|
A. Tray back |
| E. #8 - 18 x ¹⁄₄" hex- | H. Hex nuts (4) | ||
B. Tray center |
|
| head screws (4) | I. Carriage bolts (4) | |
C. Tray sides (2) | F. Flat washers (4) | J. #10 - 12 x 1¹⁄₂" slot- | |||
D. Support legs (2) | G. Lock washers (4) | head wood screws (2) | |||
Parts supplied
Check that all parts are included in parts package.
Air conditioner installation
|
| G |
F |
|
|
| E | H |
A |
|
|
B C D |
|
|
A. | E. Side curtains (2) | |
B. #8 x ³⁄₈" | F. Top channel | |
C. #8 x ³⁄₄" | G. Foam seal | |
D. #10 x ³⁄₈" | H. Side curtain frames (2) | |
Location Requirements
IMPORTANT: Observe all governing codes and ordinances.
Check the location where the air conditioner will be installed. Make sure you have everything necessary for correct installation.
The location should provide:
■Grounded electrical outlet within 4 ft (122 cm) of where the power cord exits the air conditioner.
NOTE: Do not use an extension cord.
■Free movement of air in room to be cooled.
■A large enough opening for the air conditioner. Installation parts are supplied for
■Adequate wall support for weight of air conditioner. Air conditioner weighs 80 lbs (36.3 kg) to 125 lbs (56.7 kg).
NOTE: Cabinet louvers must not be obstructed. Air must be able to pass freely through the cabinet louvers.
A
A. Cabinet louvers
3
