Whirlpool FEP330V, FEP350V, FEP310V, FEPZlOV, FEP340V Using Your Range, Using the surface units

Using Your Range

Models FEC350V,FEP350V& FEP340V

Left rear	Left front	Time bake
		switch (Models
control	control	FEC350V&
knob	knob	FEP350V)

Time bakersignal Lvm

light (Models signal signal

FEC350V& FEP350V) light light

Models FEP335V& FEP330V

Left rear	Left front
control	control
knob	knob

-.ISurface signal

Oven signal light light

Models FEP320V& FEP310V

;xtn;;mp

Right front

knob 1 control knob

Automatic oven light switch

Right front control knob

Oven temp control knob

Right rear control knob

I

Surface unit indicator

Right rear control knob

Surface unit indicator

Using the surface units

Control knobs must be pushed in before turning them to a setting. They can be set anywhere between HI and OFF.

Surface unit indicators

The solid dot in the surface unit indicator shows which surface unit is turned on by that knob.

Signal lights

The Surface Signal Light on the control panel will glow when a surface unit is on.

Until you get used to the settings, use the following as a guide. For best results, start cooking at the high settings, then turn the control knob down to continue cooking.

Use a high setting to start food cooking; to bring liquids to a boil.

Use a medium-high setting to hold a rapid boil; to fry chicken or pancakes.

Use a medium setting for gravy, puddings and icing; to cook large amounts of vegetables.

Left rear	Left front	Right front	Right rear
control knob	control knob	control knob	control knob

Oven signal light	Surface signal	Oven temp	Surface unit
	light	control knob	indicator
Model FEPllOV
Left rear	Right rear	Right front	Oven temp
control knob	control knob	control knob	control knob

I	Oven signal light
Left front control knob

Use a medium-low setting to keep food cooking after starting it on a higher setting.

Use a low setting to keep food warm until ready to serve. Set the heat higher or lower within the low band to keep food at the temperature you want.

Solid element surface units (Model FEP335V)

Before using a solid element surface unit for the first time, heat on high setting for five minutes. The surface unit will give off smoke as the protective coating, applied at the factory, finishes bonding to the surface.

Solid element surface units are made of heavy cast-iron to provide even cooking. Each surface unit has a built-in protective limiter as a safety feature. The limiter senses uneven cooking temperatures and automatically reduces the heat level. The limiter will sense uneven heat when a pan boils dry or when a pan is removed and the surface unit is left on. The heat level may also be reduced automatically if the bottom of the pan is not flat or if the pan is too large or too small for the element. This

will result in longer cooking times.

Page 5