Whirlpool oortable spa owner manual Equipment Set-Up, Installation

www.clearcreekspas.com

INSTALLATION

Equipment Set-Up

1.Remove the plastic sheet covering the spa. Use care; stepping into the spa with shoes will scratch the acrylic surface.

2.Remove any packing materials from the spa.

3.Remove each filter cartridge from its plastic bag.

4.Pull open each skimmer/filter door by the handle lo- cated in the middle of the door and remove the skimmer basket. Then insert the filter cartridge into the filter housing and re-insert the basket so that it fits in place over the filter cartridge and close the skimmer/filter door.

5.Clean the interior of the spa of any remaining construc- tion debris. Remove stubborn stains, paint, or tar with turpentine, isopropyl alcohol or paint thinner. A mild liquid dishwashing detergent on a damp cloth is fine for cleaning off other dirt. Plaster can be removed by scraping with a wooden edge; do not use a metal scraper, wire brush, or other metal tools, as they will damage the spa’s surface.

6.Install the skirt panels which were not installed on the spa at the factory. To do this, secure with the screws provided in your spa accessory package and follow instructions provided with panels.

7.On initial start-up, it is necessary to purge and sanitize the system. Carefully follow the procedure described here to purge and sanitize your spa.

•Remove the spa cover completely.

•Close the drain valve located on the suction tee.

•Fill the spa with water to its normal operating level, which is to the water level indicator mark on the skimmer/filter frame.

•Turn on circuit breakers at the main electrical panel.

•Select JETS on the SYSTEM switch.

•Add 60cc sodium dichlor (a fast dissolving granulartype of chlorine) to the water and let the whirlpool run for 15-20 minutes only.

•Turn off JETS.

•Turn off circuit breakers.

•Immediately open the drain valve and drain the spa completely.

CAUTION: Leave the rigid cover off the spa during this procedure. Do not use the spa during this procedure. Drain the spa immediately afterward.

8.Close the drain valve and fill the spa with water to approximately 180mm (7") below the spa rim, or to water line indicator mark on the skimmer frame. (See illustration on this page.)

9.Turn on circuit breakers at the main service panel.

10.Set the heater thermostat for the maximum tem- perature.

11.Test the spa for proper operation. (Refer to Operating Instructions.)

12.Refer to Water Quality section of the Operating Instructions. Test for water quality; then add treatment chemicals to ensure proper levels.

All Jacuzzi Whirlpool Bath spas are factory tested for proper operation and watertight connections prior to shipping. If leaks or other problems are detected, immediately notify your Jacuzzi Whirlpool Bath dealer or Authorized Service Agent, or call Jacuzzi Whirlpool Bath, (510) 938-7411 (510-938-7070 in California), for Warranty Service.

www.clearcreekspas.com