www.clearcreekspas.com
TROUBLESHOOTING GUIDE
PROBLEM | PROBABLE CAUSE | REMEDY |
6.Low water flow from jets.
(Continued)
E.Dirty filter.
F.Suction or discharge line partially plugged.
G.Pump running at subnormal speed.
H.Worn or damaged pump seal.
I.Subnormal voltage.
E.*
F.*
G.*
H.*
I.Call an electrician or your power company.
7. No water flow from jets. | A. Power turned off. |
| B. Selector switch in OFF. |
| C. House circuit breaker tripped; |
| no power to system. |
A. Turn on power at service panel. B. Select other function.
C. Reset circuit breaker.
D. Spa circuit protector tripped.
E. High temperature safety switch(es) tripped.
F. ELCB tripped.
G. Faulty pump or motor.
H.Motor(s) not connected.
I.Jet (or jets) closed.
D. Reset circuit protector.
E. Reset button(s) on heater after
water has cooled; see *Note if switch continues to trip.
F. Reset ELCB
G.*
H.Chech motor plug connection on System Control Module
I.Open jet.
8. Noisy pump and motor. | A. Clogged strainer(s). | A. Clean strainer(s). |
| B. Leakage of air into suction line. | B. Locate and repair leaks. |
| C. Vibrating parts attached to moto | C. Tighten fasteners. |
| or support brackets | D. Add water to normal water |
| D. Low water level. | |
| E. Damaged or worn motor | level. E. * |
| bearings. | F. * |
| F. Impeller rubbing inside pump. | |
| G. Debris inside pump. | G. * |
|
|
|
9. Water leakage at pump shaft | A. Worn or damaged pump seal. |
|
(rotating connection between |
|
|
pump and motor). |
|
|
10. Motor will not start. | A. Power off. |
| B. OFF mode selected. |
| C. House circuit breaker |
| tripped or in OFF position. D. |
| Spa circuit breakers tripped. E. |
| ELCB tripped. |
A. Turn on power at service panel.
B. Select FILTER, HTR/FILTER, or JETS mode.
C. Reset circuit breaker. D. Reset circuit breakers. E. Reset ELCB.
*Note: The skills and tools necessary for the safe repair of this spa require the services of qualified service personnel. Contact your Jacuzzi Whirlpool Bath dealer.
www.clearcreekspas.com