Whirlpool oortable spa owner manual Operation, Operating Instructions, Basic Control Set-Up

Turn dial to correct time and day. Slide tabs toward center for desired operating periods. (One tab = 2 hrs.)

TIMER

www.clearcreekspas.com

OPERATION

Operating Instructions

Now that your Quantum Plus spa is in place, you are probably eager to take advantage of its unique designed-in features— especially the patented Jacuzzi Whirlpool Bath hydromassage performance. Besides being a beautiful addition to your indoor decor or outdoor landscaping, your Jacuzzi whirlpool spa will provide you with the ultimate in spa pleasure.

Basic Control Set-Up

The control set-up on your Quantum Plus spa is designed to give you fingertip control of the heater, lights, air induction, Water Rainbow and whirlpool/filter pump and blower systems of your unit from inside or outside your spa. Follow the basic control set-up described below to familiarize yourself with the several functions of the control panels located on the top of

the spa.

CAUTION

Do not turn on power to the spa unless it is filled with water to the normal water level. (See water line indicatormark on skimmer frame.) When the power is on, the built-in timer may activate the system even though the SYSTEM is turned off at the control panel. If the spa’s motor/pump is actuated when there is not sufficient water in the unit, the circulation pump and heater could be irreparably damaged. In addition to damaging the unit, operating the spa with insufficient water could cause a fire.

• Using a garden hose, fill the spa with water to the	• Your spa is provided with a earth leakage circuit breaker
waterline indicator mark on the skimmer frame. (See
	(ELCB). At initial start-up and at least once a month
page 20 for information on using Water Rainbow as a
	thereafter, with power on, push the button located on
fill spout if desired.)
	the spa System Control Module. The switch should
• At the house service panel, turn on the circuit breaker	move to the OFF (O) position. Move the switch to the
	ON (1) position to reset. If the interrupter fails to operate
or switch that controls the electrical service to your spa.
	in this manner, there is a ground current flowing or a
(Make sure there is no other appliance on that circuit.)
	device malfunctioning, indicating the possibility of elec-
• Open the skirt door giving access to the System Control
	tric shock. Turn off power and do not use the spa until
Module.	the source of the breakdown has been identified and
	corrected.

SYSTEM CONTROL MODULE

PLUG-IN C0NNECTORS

INTERLOCK

SWITCH

TEMP.

SAFETY

SWITCH

FLOW

SWITCH

LIGHT #1

LIGHT #2

GFCI

		CAUTION			1. Push TEST button of GFCI.
This system is GFCI (Ground Fault Circuit Interrupter) pro-tected for your
safety. Bypassing the GFCI or tampering with the system in any way may					2. RESET button should pop out. This should cut offpower
cause electrical shock, in-jury or death and will void the warranty.				GFCI	to the system. CAUTION: if RESET button does not
protection does not extend to 230 V AC circuit conversion. If test indi-cates that the GFCI					pop out, or if RESET button does pop out and system
is not functioning, DO NOT USE THE UNIT until the electrical					is still on, DO NOT USE YOUR SPA.
	problem has been corrected. (See installation instructions.) TEST THE GFCI			3. Ifthe GFCI tests okay, restore power by pushing in the
ONCE A MONTH.					intoresetplacebutton.andTheremainsRESETdepressed.button mustbe pushed until it locks
TEST PROCEDURE
Unit must be filled to proper water level and correct power supplied.			IF THE GFCISPA!FAILCONTACTTO RESETA PROPERLY,QUALIFIEDDOELECTRICIAN.NOT USE THE

HIGH TEMPERATURE SAFETY SWITCH	CAUTION: DO NOT BREAK DOOR SEAL;
High temperatures above the thermostat range will	OPENING DOOR VOIDS W ARRANTY
cause the high temperature safety switch to trip and	THIS EQUIPMENT REQUIRES QUALIFIED SERVICE
the system to turn off. See operating instructions.
When water temperature is less than 100° F., reset	PERSONNEL FOR PROPER REPAIR. CONTACT YOUR
by pressing the safety switch reset button located on	JACUZZI WHIRLPOOL BATH DEALER FOR SERVICE.
the cover of the heater enclosure.	NO USER SERVICABLE PARTS BEHIND THIS DOOR.

JETS

MOT OR/

PUMP

BLOWER

HEATER

FILTER

MOT OR/ PUMP

www.clearcreekspas.com