www.clearcreekspas.com
OPERATION
Basic Control Set-Up (continued)
•Make sure the circuit breakers are in the ON (1) position.
•Locate the HIGH TEMPERATURE SAFETY SWITCHES which are raised buttons on the end of the heater. Push both buttons to be sure it is in the reset mode. The purpose of both switches is to shut down the spa if the water becomes excessively hot. If, for some reason, the switches are tripped, the reset button must be pushed in for the heater to operate again after the water has cooled to about 38°C (100°F).
•Set the
and the HEATER knob set to the desired tempera- ture, the timer will activate the heater and filter pump to operate during the time period set on the timer. With the SYSTEM switch turned OFF and the HEATER CONTROL knob turned to its lowest set- ting, the water will be filtered without heat during the time period set on the timer.
• Close the redwood skirt door.
HIGH TEMPERATURE SAFETY RESET BUTTON
CIRCUIT |
BREAKER |
BUTTONS |
wish the filter system to operate. Note that the timed |
mode can begin at any time of day or night at any |
specified day of the week. |
Setting the Timer
The
www.clearcreekspas.com