Surface units and reflector bowls
RemovingReplacing
1. Be sure surface units are OFF.
2. Line up opening in the reflector bowl with the surface unit receptacle.
1.Be sure surface units are OFF and COOL.
2.Lift the edge of the unit opposite the recep- tacle just enough to clear the reflector bowl.
3.Pull the’surface unit straight away from the receptacle
3.Hold the surface unit as level as possible
with the terminal just started into the receptacle.
4.While pushing the surface unit terminal into
the receptacle, lift a little on the edge of the unit nearest the receptacle.
5.When the terminal is pushed into the re-
ceptacle as far as it will go, the surface unit will fit into the reflector bowl
Reflector bowls reflect heat back to the utensils on the surface units. They also help catch spills. When they are kept clean, they reflect heat better and look new longer.
If a reflector bowl gets discolored, some of the utensils used may not be flat enough. Or some may be too large for the surface unit. In either case, some of the heat that is meant to go into or around a utensil goes down and heats the reflector bowl. This extra heat can discolor it.
4.Lift out the reflector bowl.
