Alignment pin

CARING FOR YOUR RANGE

SEALED SURFACE BURNERS AND COOKTOP (CONT.)

To clean the burners:

1.Pull the burner cap straight up from the burner base.

2.Clean the burner cap with warm, soapy water and a sponge. You can also clean it with a mildly abrasive scrubbing pad or cleanser.

Do not clean the burner cap in a dishwasher or self-cleaning oven.

3.If the gas tube opening has become soiled or clogged, use a cotton swab or a soft cloth to clean the area.

4.If the ports are clogged, clean them with a straight pin. Do not enlarge or distort the port. Do not use a wooden toothpick. If

the burner needs to be adjusted, call a qualified technician for service.

5.After cleaning the gas tube opening and ports,

replace the burner cap. To replace the burner cap, make sure the alignment pins on the cap are properly aligned with the burner base.

6.Turn on the burner to see if it will light. If the burner does not light after you have cleaned it, recheck cap alignment or contact an authorized service technician. Do not service the sealed burner yourself.

REMOVING THE OVEN DOOR

For normal use of your range, you do not need to

Insert door

remove the door. However, if you have to remove

removal pin here

the door follow the instructions in this section.

 

NOTE: If the door removal pins included in the

 

Anti-Tip Bracket Package are not available, nails or

 

screws may be used. Be careful that the length of

 

the nail or screw does not damage the oven by

 

chipping or scratching the porcelain surface.

 

Oven door

Range

Hinge hanger

34

Page 34
Image 34
Whirlpool SF395LEE manual Removing the Oven Door, To clean the burners, Insert door, Oven door Range Hinge hanger