Surface Burners
Lift up the cooktop, following the instructions on page14.
Wipe off surface burners with warm soapy water and a soft cloth after each use.
Occasionally check surface burner flames for size and shape as shown. If flames do not burn properly, you may need to remove the surface burners for cleaning (see pageM), or call a qualified technician for burner adjustments.
For models SF5340ER, SF514OSR/ERand SF514ESR/ER;to adJust the HI and LO sefflngs on the control knobs:
1. Turn on the surface burners, then set the controls to LO.
2.Wlthout changing the burner sefflngs, remove the control knobs.
3.Firmly grasp the control stem and insert a small bladed screwdriver into the end of the stem. Turn the screwdriver in either direction until the flame height is Yein (.318cm] or lower in size. Flame must be large enough to malntaln a STABLEFLAME on all burner ports.
NEVERADJUST THEFLAME SIZEAT THEMEDIUM SEITING.
The Oven Door
Removing the oven door will make it easier to clean the oven.
Open the door to the first stop position.
2.Hold the door at both sides and lift off of hinges at bottom corners of door.
3.To replace, fit the bottom corners of the door over the ends of the hinges.
Push the door down evenly. The door will close only when it is on the hinges correctly
