Oven Door
For normal range use, it is not suggested to remove the oven door. However, if necessary, follow these instructions. The oven door is heavy.
Before Removing:
1.Use a putty knife or screwdriver and insert it at the bottom corner of the door stop clip.
2.Pry door stop clip free and remove from front frame hinge slot. Take care not to scratch finish.
3.Repeat procedure for other door stop clip.
To Remove:
1.Open the oven door. Insert door removal pins, included with your range, into both hinge hangers. Do not remove the pins while the door is removed from the range.
3.Tilt top of door toward range. Slide hinge hangers down onto front frame support pins. Make sure the hinge hangers are fully seated and engaged on the support pins.
4.Insert the door stop clip with the angular surface at the top of the frame hinge slot, then push in the bottom of the clip until flanges are flush with the front frame.
5.Open the door completely and remove the door removal pins. Save door removal pins for future use.
6.Close the door.
2.Carefully close the door until it rests against the door removal pins.
3.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.
4.Pull door straight up, then toward you. Hinge hangers will slide out of front frame hinge slot. Do not remove door removal pins until the door is replaced on the range.
TROUBLESHOOTING
Try the solutions suggested here first in order to avoid the cost of an unnecessary service call.
Nothing will operate
■Is the power supply cord unplugged? Plug into a grounded 3 prong outlet.
■Has a household fuse been blown or has the circuit breaker been tripped?
Replace the fuse or reset the circuit.
Surface burners will not operate
■Is this the first time the surface burners have been used? Turn on any one of the surface burner knobs to release air from the gas lines.
■Is the control knob set correctly? Push in knob before turning to a setting.
■Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” section.
On open burner models, see “Surface Burners” section.
To Replace:
1.Grasp the door on the sides with your fingers on the front of the door and your thumbs on the inside surface.
2.Hold oven door so that the top edge of each hinge hanger is horizontal. Insert hinge hangers into the front frame hinge slots.
Surface burner flames are uneven, yellow and/or noisy
■Are the burner ports clogged?
On sealed burner models, see “Sealed Surface Burners” section.
On open burner models, see “Surface Burners” section.
■On models with caps, are the burner caps positioned properly?
See “Sealed Surface Burners” section.
■Is the burner damaged?
On models with caps, look for a warped cap. If cap will not spin freely on a flat surface, painted side down, the cap is warped. Switch cap with a different surface burner to check for further warping. Contact a service technician or see “Assistance or Service” section.
18
