EndofCycleSignal
End of Cycle Signal
The End of Cycle Signal produces an audible sound when the drying cycle is finished. Promptly removing clothes at the end of the cycle reduces wrinkling.
Press END OF CYCLE SIGNAL until the desired volume (Loud, Soft or Off) is selected.
NOTE: When the WRINKLE SHIELD™ setting is selected and the End of Cycle Signal is on, a tone sounds every 5 minutes until the clothes are removed, or the WRINKLE SHIELD™ setting ends.
ChangingCycles,Modifiers
andOptions
You can change Automatic and Timed Cycles, Modifiers and Options anytime before pressing Start.
■Three short tones sound if an unavailable combination is selected. The last selection will not be accepted.
Changing Cycles after pressing Start
1.Press PAUSE/CANCEL twice.
2.Select the desired cycle and options.
3.Press START. The dryer starts at the beginning of the new cycle.
NOTE: If you do not press Start within 5 minutes of selecting the cycle, the dryer automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change an Option or Modifier anytime before the selected Option or Modifier begins.
1.Press PAUSE/CANCEL once.
2.Select the new Option and/or Modifiers.
3.Press START to continue the cycle.
NOTE: If you happen to press PAUSE/CANCEL twice, the program clears and your dryer shuts down. Restart the selection process.
Changing the Preset Dryness Level Settings
If all of your loads on all Auto Dry cycles are consistently not as dry as you would like, you may change the preset Dryness Level settings to increase the dryness. This change will affect all of your Auto Dry cycles.
Your Dryness Level settings can be adjusted to adapt to different installations, environmental conditions or personal preference. There are 3 drying settings: 1 (factory preset dryness level),
2 (slightly dryer clothes, approximately 15% more drying time) and 3 (much dryer clothes, approximately 30% more drying time).
1.The Dryness Level settings cannot be changed while the dryer is running.
2.Press and hold the DRYNESS button for 5 seconds. The dryer will beep, and “CF” will be displayed for 1 second followed by the current drying setting.
3.To select a new drying setting, press the DRYNESS button again until the desired drying setting is shown.
NOTE: While cycling through the settings, the current setting will not flash, but the other settings will flash.
4.Press START to save the drying setting.
5.The drying setting you selected will become your new preset drying setting for all Auto Dry cycles.
DryingRackOption
Use the Drying Rack to dry items such as sweaters and pillows without tumbling. The drum turns, but the rack does not move.
If your model does not have a drying rack, you may be able to purchase one for your model. To find out whether your model allows drying rack usage and for information on ordering, please refer to the front page of the manual or contact the dealer from whom you purchased your dryer.
NOTE: The rack must be removed for normal tumbling. Do not use the automatic cycle with the drying rack.
To use the drying rack
1.Open dryer door.
A
A. Front edge
2.Place drying rack inside dryer drum, positioning the back wire on the ledge of the inner dryer back panel. Push down on front edge of drying rack to secure at the front of the dryer.
B 
A 
A. Dryer rack front edge
B. Dryer back panel
3.Put the wet items on top of the rack. Leave space between the items so air can reach all the surfaces.
NOTE: Do not allow items to hang over the edge of the rack.
4.Close the door.
18
