IMPORTANT SAFETY INSTRUCTIONS
WARNING: To reduce the risk of fire, electric shock, or injury to persons when using the dryer, follow basic precautions, including the following:
■Read all instructions before using the dryer.
■Do not place items exposed to cooking oils in your dryer. Items contaminated with cooking oils may contribute to a chemical reaction that could cause a load to catch fire.
■Do not dry articles that have been previously cleaned in, washed in, soaked in, or spotted with gasoline, dry- cleaning solvents, or other flammable or explosive substances as they give off vapors that could ignite or explode.
■Do not allow children to play on or in the dryer. Close supervision of children is necessary when the dryer is used near children.
■Before the dryer is removed from service or discarded, remove the door to the drying compartment.
■Do not reach into the dryer if the drum is moving.
■Do not install or store the dryer where it will be exposed to the weather.
■Do not tamper with controls.
■Do not repair or replace any part of the dryer or attempt any servicing unless specifically recommended in this Use and Care Guide or in published
■Do not use fabric softeners or products to eliminate static unless recommended by the manufacturer of the fabric softener or product.
■Do not use heat to dry articles containing foam rubber or similarly textured
■Clean lint screen before or after each load.
■Keep area around the exhaust opening and adjacent surrounding areas free from the accumulation of lint, dust, and dirt.
■The interior of the dryer and exhaust vent should be cleaned periodically by qualified service personnel.
■See installation instructions for grounding requirements.
SAVE THESE INSTRUCTIONS
IMPORTANT: The gas installation must conform with local codes, or in the absence of local codes, with the National Fuel Gas Code, ANSI Z223.1/NFPA 54 or the Canadian Natural Gas and Propane Installation Code, CSA B149.1.
The dryer must be electrically grounded in accordance with local codes, or in the absence of local codes, with the National Electrical Code, ANSI/NFPA 70 or Canadian Electrical Code, CSA C22.1.
INSTALLATION INSTRUCTIONS
Tools andParts
Gather the required tools and parts before starting installation. Read and follow the instructions provided with any tools listed here.
Parts supplied:
Remove parts package from dryer drum. Check that all parts were included.
■8" or 10" pipe wrench
■8" or 10" adjustable wrench (for gas connections)
■
■Adjustable wrench that opens to 1" (2.5 cm) or
■Level
■¼" nut driver or socket wrench
■Knife
■Vent clamps
■
■Caulking gun and compound (for installing new exhaust vent)
■Pliers
4 leveling legs
Parts needed:
Check local codes and consult gas supplier. Check existing gas supply, electrical supply and venting, and read “Electrical Requirements,” “Gas Supply Requirements” and “Venting Requirements” before purchasing parts.
Mobile home installations require special parts (listed following) that may be ordered by calling the dealer from whom you purchased your dryer. For information on ordering, please refer to the “Assistance or Service” section of this manual. You may also contact the dealer from whom you purchased your dryer.
■Mobile home installation kit. Ask for Part Number 346764.
■Metal exhaust system hardware.
4
