WhisperKool PLATINUM 8000 THROUGH-THE-WALL Installation without ductwork, Mounting Flange Pieces

THROUGH-THE-WALL INSTALLATION (without ductwork)

Mounting Flange Pieces

There are four individual pieces located in Kit 2 of your enclosed accessory kits. These flange pieces are de- signed to be used on the backside of the Extreme Series to mount to the exterior wall. There are three punch- outs located on the exterior of the housing. The punch-outs are designed for specific through-the-wall installa- tion mounts. Please refer to the illustration for location of the punch-outs.

#1. Retrofit your current WhisperKOOL cooling unit

#2. Middle wall installation

#3. Flush mount to exterior wall

Back of unit

Applying Insulation Tape Locate the four precut pieces of black foam tape included with the system. There should be two larger pieces and two smaller pieces. Once you have attached the flange pieces to the unit, peel back the white- paper adhesive covering and place on the corresponding size of flange. The large pieces are applied to the top and bottom of the unit and the smaller pieces to the right and left side flanges. This foam creates a tight seal between the flange and the wall.

Front of unit

Page 15