Emerson 36J55, 36J22, 36J54 System Wiring, Single Stage Valve Features, Terminals and Wiring

INSTALLATION

SYSTEM WIRING

REFER TO AND FOLLOW THE APPLIANCE MANUFACTURER'S WIRING DIAGRAM. REFER TO FIGURES 3 AND 4 FOR TERMINAL IDENTIFICATION.

4.693” Inlet to Outlet

NOTE

All wiring should be installed according to local and national electrical codes and ordinances.

Always check that the electrical power supply used agrees with the voltage and frequency shown on the gas control.

Outlet Pressure Post

.339 Dia. +DFT.

(Set Screw: 3/32” Hex Head)

Accept 5/16” ID Hose Connection

On/Off	Main and
Switch	Redundant
	Valves

		Regulator Cover Screw
		(Reg. Adj. Beneath This Screw)
Inlet Pressure Post	On/Off	3/16” Ground Terminal
		Control I.D. Label
.339 Dia. +DFT.	Switch
(Set Screw: 3/32” Hex Head)
Accept 5/16” I.D. Hose	1/4” x .032” THK. Male
Connec￿on
	Spade Terminals (2)

Fig. 3 – Single Stage Valve Features, Terminals and Wiring

Outlet Pressure Post

Set Screw: 3/32” Hex Head

(.339 Dia. + DFT.)

Accepts 5/16” Hose Connection

	4.693” Inlet to Outlet			High Fire Regulator
				Cover Screw
				(Reg. Adj. Beneath
				the Screw)
				Low Fire Regulator
				Cover Screw
				(Reg. Adj. Beneath
				the Screw)
			3/16” x .032” Thick Male
			Spade Terminal (1)
Inlet Pressure Post		On/Off Switch
		Control I.D. Label
Set Screw: 3/32” Hex Head
(.339 Dia. + DFT.)			1/4” x .032” Thick Male
Accepts 5/16” Hose Connec†on
			Spade Terminals (3)
					M
				On/Off		Main and
				Switch		Redundant
					C	Valves (Low Fire)
		3/16” Ground Terminal			C	2nd Stage

Valve (High Fire)

Hi

Fig. 4 – Two-Stage Valve Features, Terminals and Wiring

4