Fault |
| Probable Cause |
| Suggested remedy | |
|
|
|
|
| |
| 1. | Blade speed too high for feed | 1. | Reduce blade speed and feed | |
Bad cuts (rough) |
| pressure. |
| pressure. | |
|
|
|
| ||
| 2. | Blade is too coarse. | 2. | Replace with finer blade. | |
|
|
|
|
| |
Blade is twisting | 1. | Blade is binding in the cut. | 1. | Decrease feed pressure. | |
2. | Blade tension too high | 2. | Decrease tension on Blade | ||
| |||||
|
|
|
|
| |
| 1. | Blade guides worn | 1. | Replace blade guides. | |
Unusual wear on | 2. | Blade guide bearings not adjusted. | 2. | Adjust blade guide bearings. | |
side/back of blade | 3. | Blade guide bearing bracket is | 3. | Tighten blade guide bearing | |
|
| loose. |
| bracket. | |
|
|
|
|
|
22
