Windsor 10052470, SG32, SG36, SG28 3-16, Emptying And Cleaning Tanks Recovery Tank, Solution Tank

EMPTYING AND CLEANING TANKS RECOVERY TANK

1.Touch the one-touch switch (#1) on the control panel to raise the scrub deck, stop the motors, and solution flow, raise the squeegee and turn off vacuum motors.

2.Park the machine next to a floor drain. Drain hose is on left rear corner of machine.

3.Turn off the key switch and set the machine’s parking brake.

4.Unhook the drain hose from retainer. Unscrew T-handle on plug enough to loosen plug and lower hose in direction of drain. Stand behind end of hose. Recovered solution will come out with force. Slowly remove plug from drain hose.

5.Remove recovery tank dome.

6.Flush the recovery tank out with clean water. Repeat until clean water comes out of drain hose. Do not use water hotter than 140' (60'C) to clean the tank. Damage to tank may occur.

7.Replace plug and secure drain hose in bracket.

8.If machine is to be stored, leave recovery tank dome open and drain hose plug off.

MACHINE OPERATION

SOLUTION TANK

1.Park the machine next to a floor drain. Drain hose is on left rear adjacent to recovery tank drain hose.

2.Turn off the key switch and set the machine’s parking brake.

3.Unhook the small drain hose from the retainer. Lower hose in direction of the drain.

4.Remove the solution tank cover.

5.Flush the solution tank out with clean water and run several gallons of clean water through systems. Do not use water hotter than 140º F (60º C) to clean tank. Damage may occur.

NOTE: Never allow solution to remain in tank. Damage to tank, seals and valves could occur.

6.Secure drain hose in bracket.

REAR VIEW			TOP VIEW
RECOVERY	SOLUTION
DRAIN HOSE	DRAIN HOSE	RECOVERY	SOLUTION
		TANK DOME
			TANK COVER

86037580 GLIDE 01/03/07 3-16