MAINTENANCE
3.Locate release lever on top of brush or pad driver. With finger rotate release lever against spring pressure counter clockwise. Brush/pad driver will release and drop down.
4.To reinstall, center the cut out of the release lever plate on brush/pad driver to be installed under the brush drive hub.
5.Raise brush/pad driver up until assembly contacts brush hub. Rotate slightly until driver engages release lever plate.
6.While holding upward pressure, rotate brush/pad driver assembly clockwise. When fully engaged, release lever plate will rotate under spring pressure to lock assembly.
NOTE: Check that release plate is completely closed and pad/brush is securely attached. Damage to driver or brush could occur.
7.Repeat the procedure for the opposite side of the machine.
8.The center brush should be changed from the right side.
9.Reinstall the side squeegees.
6.VACUUM FILTER
The vacuum filter is located inside the recovery tank. The vacuum filter prevents debris from entering the vacuum motor. Daily remove and clean filter of any debris for maximum airflow.
7.FLOAT SWITCH
The float switch is located inside the recovery tank. The purpose of the float switch is to notify the user that the recovery tank is full. When the float switch is activated, the scrub brush motors and solution flow will stop, the scrub deck will raise, the squeegee will rise after 60 seconds, and the vacuum motor will turn off 10 seconds later.
Icon appears on information screen 1 when
float switch is activated.
8.SOLUTION STRAINER
The solution strainer is located behind the right rear wheel of the Glide. The solution strainer protects the solenoid valve from debris. If there is little or no solution flow to the ground, check the strainer for debris. Drain the solution tank and clean the solution strainer. To remove the strainer, turn the bottom part of the strainer counterclockwise until the bottom is separated. Clean out the debris from the wire mesh and
9.BRAKE
(Refer to Brake Group in the Parts section of the manual).
The brake pedal and parking brake operate the self- centering front wheel disc brake. The disc and caliper should be inspected every 200hours of operation for cracks and disc wear. The brake should be adjusted so that the disc pads are as close to the disc as possible, without causing brakes to drag.
BRAKE ADJUSTMENT
FOR SAFETY: Before leaving or servicing machine, stop on a level surface, turn off machine and remove key.
1.Disconnect batteries from machine.
2.Turn the steering wheel fully to the left.
3.Locate the brake adjustment screw on the brake caliper.
4.Loosen the lock nut.
5.Turn adjustment screw in until finger tight, then back off 1/8 turn.
6.Hold adjustment screw and tighten lock nut.
10.STEERING CHAIN TENSIONER
(Refer to Steering Group in parts section of manual).
The steering chain transfers power from the steering shaft to the drive wheel, controlling steering response. Check the chain condition and tension every 200 hours of operation. Proper chain tension is important to maintain steering response. The chain should deflect 1/16 in. Use a light spray lube if needed.
STEERING CHAIN TENSIONER ADJUSTMENT
1.Locate chain tensioner bolts.
2.To increase tension, tighten lock nuts retaining chain tension plate.
3.To decrease tension, loosen lock nuts retaining chain tension plate.
86037580 GLIDE 01/03/07 |
