MAINTENANCE
TO CHARGE BATTERIES
|
| ! |
|
|
|
|
|
| When servicing machine, | |
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
| avoid contact with acid. | ||
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
| ||||
|
|
|
|
|
|
|
|
|
| Batteries emit hydrogen |
|
|
|
|
|
|
|
|
|
| |
|
|
| ! |
|
|
|
|
|
| gas. Explosion or fire can |
|
|
|
|
|
|
|
|
| ||
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
|
|
| |
|
|
|
|
| ||||||
result. Keep sparks and open flame away. Keep covers open when charging.
|
|
|
|
| Wear eye protection and |
|
|
|
|
| |
| ! |
|
|
| protective clothing when |
|
|
|
|
| |
|
|
|
|
| |
|
|
working with batteries.
! | Charge batteries in a well |
ventilated area. |
1.Stop the machine in a clean, well ventilated area next to the charger.
2.Turn the machine off and set parking brake.
FOR SAFETY: Before leaving or servicing machine, stop on level surface, apply parking brake, turn off machine and remove key.
3.Raise the seat and raise the support arm to lock in place.
| ! |
|
|
|
|
| Batteries emit hydrogen |
|
|
|
|
|
| ||
|
|
|
|
|
| gas. Explosion or fire can | |
|
|
|
|
|
| ||
|
|
|
|
|
|
| |
|
|
|
|
|
|
|
result. Keep sparks and open flame away. Keep covers open when charging.
4.Check the electrolyte level in each battery cell. Before charging, add just enough water to cover up the plates. After recharging has completed, add just enough water to bring up the level to the indicator ring. If water level is to high before charging, normal expansion of the electrolytes may cause and overflow, resulting in loss of battery acid balance and damage to the machine.
5.Replace battery caps, and leave them in place while charging.
6.Unplug the battery connector from the machine. Unplug the battery charger from power outlet.
FOR SAFETY: When charging, connect the charger to the batteries before connecting the charger to the AC wall outlet. Never connect the charger to the AC first. Hazardous sparks may result.
7.Use a 36 volt DC charger which will automatically shut off when the batteries are fully charged to charge the six battery pack.
8.Plug the charger into the battery connector. Plug battery charger into power outlet. The charger gauge should indicate that the batteries are charging. If the charger does not automatically start up, verify that charger is plugged into batteries.
9.When the batteries are fully charged, disconnect the charger from the batteries.
10.Connect the batteries to the machine connector.
11.Check the electrolyte level. It should be up to the indicator ring. If necessary, add distilled water.
12.Lower the seat.
LOW BATTERY SHUT-DOWN
The electronic system is equipped with battery voltage sensors. When the batteries are exhausted to a preset level, the scrubbing system will shut down to protect the batteries from damage, and the battery lockout icon will appear on the display.
86037580 GLIDE 01/03/07 |
