TO REPLACE OR ROTATE REAR SQUEEGEE BLADES
1.With the squeegee in the up position, turn off the key switch and set the parking brake.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine and remove key.
2.Unlock and pull open latch on rear of squeegee tool.
3.Remove blade retainer straps from squeegee tool.
4.Remove squeegee blade from locating pins on squeegee tool and rotate to new position or replace as required.
5.Install blade on locating pins of squeegee tool.
6.Install squeegee retainer straps.
7.Fasten and lock latch. Latch is adjustable. Adjust latch only tight enough to take up slack in retaining strap.
NOTE: Changing of squeegee blades does not always necessitate a readjustment. Refer to section on adjusting squeegee.
TO REMOVE SQUEEGEE ASSEMBLY
1.With the squeegee in the up position, turn off the key switch and set the parking brake.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine and remove key.
2.Disconnect vacuum hose and loosen the two squeegee retaining knobs.
3.Pull squeegee assembly rearward from the lifting carrier.
4.With squeegee assembly on bench inspect or repair as necessary.
5.To reinstall, align squeegee assembly to lift carrier. Push forward until squeegee is fully engaged.
6.Tighten knobs.
7.Attach vacuum hose.
MAINTENANCE
TO REPLACE OR ROTATE FRONT SQUEEGEE BLADES
1.With squeegee assembly on bench, loosen retaining bolt and locking nut on the left side of the retaining strap.
2.Remove front retainer strap.
3.Remove squeegee blade from locating pins on squeegee tool and rotate to new position or replace as required.
4.Install blade on locating pins of squeegee tool.
5.Replace front retainer strap.
6.Secure strap by tightening retaining bolt and locking nut on retainer strap.
NOTE: Changing of squeegee blades does not always necessitate a readjustment. Refer to section on adjusting squeegee.
86037580 GLIDE 01/03/07 |
