MAINTENANCE
2. SQUEEGEE ADJUSTMENT
Adjusting the squeegee is a
TO ADJUST SQUEEGEE PITCH
1.Choose a smooth, level surface. Turn on the key switch, release the machine parking brake, lower the squeegee and drive forward at least 2 feet (60 cm).
2.With the squeegee down, stop the machine and set the parking brake. Do not allow the machine to roll back.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine and remove key.
3.Determine the differences, if any, in deflection of the squeegee blade between each end and the middle. Proper adjustment is obtained when deflection is equal all the way across tool. This should correspond to the bubble being in the middle position of the spirit level.
4.To decrease the deflection of the squeegee blade at the ends, turn knob on squeegee trailing arm clockwise. To increase the deflection at the ends of the squeegee assembly, turn knob counter clockwise.
5.Again check the deflection of the squeegee blades. Repeat steps 1 through 4 until the deflection is equal across the entire rear squeegee blade.
TO ADJUST SQUEEGEE DEFLECTION
3/8”
PROPER DEFLECTION OF SQUEEGEE BLADE
1.Choose a smooth, level surface. Lower the squeegee and drive forward at least 2 feet.
2.With the squeegee down, stop the machine and set the parking brake. Do not allow the machine to roll back.
FOR SAFETY: Before leaving or servicing machine; stop on level surface, turn off machine and remove key.
3.Observe the amount of squeegee deflection. It should deflect 3/8in (9.5 mm) across the entire width of the squeegee.
4.To adjust the squeegee deflection, loosen knob on the squeegee slide bar.
5.Sliding bar to left increases deflection. Sliding bar to right decreases deflection.
6.Tighten knob on squeegee slide bar.
7.Turn on the key switch, release the machine parking brake. Raise, then lower squeegee assembly by pressing the vacuum switch. Drive forward at least 2 feet.
8.Repeat steps 2 through 7 until defection of 3/8 in. (9.5 mm) is reached.
SGJ32 86037680 01/03/07 |