Windsor SGJ32 3-15, To Begin Scrubbing, To Stop Scrubbing, Emergency Stop Procedure, Double Scrub

MACHINE OPERATION

TO BEGIN SCRUBBING

	When operating the
!
	machine around people,

pay close attention for unexpected movement. Use extra caution around children.

1.Place right foot on brake pedal or check to make sure parking brake has been set.

2.With directional pedal in neutral turn key switch to “ON”.

3.Release brake.

4.Press the directional pedal to travel in the desired direction and steer to the start of the scrub pattern.

5.Press the one-touch switch (#1) on the control panel. The brush motors will start, the scrub deck will lower to the light scrub position, the solution will begin to flow, the squeegee will lower to the floor and the vacuum motors will start.

6.Adjust the speed of the machine, solution flow and scrub brush pressure as necessary. NOTE: Once solution flow rate is set it is not necessary to shut off solution when stopping scrubbing. Solution flow is automatically shut off when brush motors stop. When brush motors are activated, flow automatically resumes.

!	Flammable liquids and/or
	reactive metals can cause

explosions or fire! Do not pick up.

TO STOP SCRUBBING

1.Press the one-touch switch (#1) on the control panel. The brush motors will stop and the scrub deck will raise to the park position. After 15 seconds, the squeegee will raise, and 15 seconds later the vacuum motor will turn off. This delay is to clear the vacuum hose of recovered solution.

2.Allow directional pedal to return to neutral.

3.Apply brake to stop machine.

4.Turn key switch off.

5.Set parking brake.

FOR SAFETY: Before leaving or servicing machine; stop on level surface, set parking brake, turn off machine and remove key.

EMERGENCY STOP PROCEDURE

1.Turn key switch to off position. If an electrical problem is suspected push in emergency stop button.

2.Release pressure on directional pedal.

3.Apply brakes.

NOTE: Turning the key switch off during normal running operation will stop all motors and actuators. When the key is turned back on the system will automatically return scrub deck and squeegee to raised position.

DOUBLE SCRUB

Floors which are heavily soiled or have thick accumulation of floor finish may not clean sufficiently with one pass. In these cases it will be necessary to double scrub.

To double scrub, make the first pass over the surface being cleaned with the squeegee up, the solution on, and brushes down. This allows the solution to stay in contract with the soil while loosening the surface accumulation with the brushes. Allow time for the first application to stay in contact with floor. Length of time between the first and second pass depends on amount of accumulation and the type of chemical being used. A second scrubbing with the squeegee down and again the solution and brushes on will further loosen soil. The additional application of solution will further assist the difficult cleaning job. Caution should be used when double scrubbing, maintain safe driving speed on wet floors.

3-15 SGJ32 86037680 01/03/07