Wolf Cinema Owner's Manual
B-39
Reading the Conguration of a Port
P1 = <c>‘port’ same values for ‘port’ as above
example:
(rem? C2): returns (rem! C002 r 0115200)
sending arbitrary Data Out a Port
P1 = Port Same values for ‘port’ as above
P2=DataThedatatosendoutthespeciedport
example:
(rem 2 “a123”): The data a123 is sent out the OUT port without any other protocol
characters. Some codes are not standard aSCii characters. These can be sent by
 usinganyoftheescapecodesdenedinthesectionontextparameters.
(rem 2 “123\h1645): Sends the following bytes: 0x31,0x32,0x33,0x16,0x34,0x35
Reading arbitrary Data from a Port
P1 = Port Same values for ‘port’ as above
example:
(rem? 2): returns (rem! 002 “1234”). “1234” is the data returned from the remote
equipment.
ROG Red Odd Gain
Set or request the red Odd Gain(0-255)foraspecicsourcesetup.YoucansetanOddGain
valuefortwoseparateanaloginputpaths.TherstinputpathisInput1(BNCconnectors).The
second input path is one of: input 2 (DVi-a connector), or input 5 or input 6 (one of the analog
option cards).
To leave one of the input values unaffected, enter a value of 0 for the input. if only one value is
specied,thenbothinputpathswillhavethesamevalue.
examples:
(rOG 130 135) Sets the BnC analog path to 130, the DVi/option card path to 135.
(rOG 0 120) leaves the BnC path as it was, the DVi/option card path to 120.
(rOG 125) Sets both paths to 125.
ROO Red Odd Offset
Set or request the blue Odd offset (0-255)foraspecicsourcesetup.YoucansetanOddOffset
valuefortwoseparateanaloginputpaths.TherstinputpathisInput1(BNCconnectors).The
second input path is one of: input 2 (DVi-a connector), or input 5 or input 6 (one of the analog
option cards).
To leave one of the input values unaffected, enter a value of 0 for the input. if only one value is
specied,thenbothinputpathswillhavethesamevalue.

3.129 ROG

Red Odd Gain

3.130 ROO

Red Off Offset

AppendixB►SerialCommunications