Wolf Cinema Owner's Manual B-22
FRD Frame Delay
Use FrD to adjust the number of lines of delay between the input and output frames (range
varies with incoming signal).
FRZ Freeze Image
FrZ 1 = freeze the image. FrZ 0 = unfreeze the image.
Fse Fan sensor enable
Use FSe if you want the projector to shut down 3 minutes after a critical cooling fan failure. FSe
1=enabled,FSE0=disabled.NOTE:Denitionofawhichcoolingfaniscriticalvarieswith
projector model.
FYI For Your Information
The projector broadcasts an Fyi message when it detects a change in status. The Fyi message
contains the relevant status code followed by its new state (P1), up to 2 additional parameters of
detail, and a brief text description. The address of the source projector precedes the Fyi code.
NOTE: FYI messages are gated by the Error Message Enable (EME) control. Turning off EME
also turns off FYI.
status Code new state (P1) Meaning and additional Parameters
001 Power 0 = Off 1 = On 2 = Boot 10
= Cool Down 11 = Warm Up P1 value indicates the new “Power” state
detected.
002 Proj. address ##### (5-digit address) P1 value indicates the new address of
this source projector.
003 Proj. Selected 0 = rS232 inactive, Ui
inactive 1 = rS232 inactive,
Ui active 2 = rS232 active,
Ui inactive 3 = rS232
active, Ui active
This projector has been activated or
inactivated via the PrOJ key or the aPJ
serial message.
004 Baud rate ####### (7-digit baud rate) P1 value indicates the new baud rate.
005 Standby 0 = Off 1 = On P1 value indicates whether the system is
in standby mode
006 Signal 0 = Good Signal 1 = Signal
missing 2 = bad sync P1 describes signal detection P2 = hor.
frequency of signal P3 = vert. frequency
of signal
007 OSD 0 = Off 1 = On P1 value indicates whether the on-
screen display is on or not.
009 Shutter 0 = Open 1 = Closed P1 value indicates whether the shutter is
open or closed.
010 input 0 = Open 1 = Closed P1 describes the current channel
number P2 = Switcher# (projector is
always switcher “000”) P3 = Slot#
011 Picture mute. 0 = Off 1 = On P1 value indicates whether the picture is
displayed or not
012 PiP. 0 = Off 1 = On P1 value indicates whether Picture-in-
Picture mode is on or not
255 General / misc. ### (3-digit channel
number) P1 describes miscellaneous general
state detected

3.53 FRD

Frame Delay

3.54 FRZ

Freeze Image

3.55 Fse

Fan sensor enable

3.56 FYI

For Your Information

AppendixB►SerialCommunications