Wolf Cinema Owner's Manual 2-14

DVI Digital Video >

InPUT 3 and InPUT 4 provide simultaneous connection of both a composite video source
(InPUT 3) and an S-Video source (InPUT 4). See Figure 2.9.
Use the DVi-i connector at InPUT 2 to connect either analog or digital video devices to the
projector. When connecting devices that transmit an analog video signal such as VCrs, laptops,
and PCs use the DVi cable provided with the projector. Plug the DVi-i (single link) connector
end to the projector and the 15-pin VGa connector to the device.
Use a cable with DVi-i connectors at both ends to connect devices that transmit digital and
analog video signals such as high-quality DVD players, satellite receiver and digital cable TVs.
nOTes: 1) To ensure true digital output from devices that transmit digital signals, connect to
the DVI-I connector. 2) DVI loop through is not available unless you have the optional DVI Input
Module installed at InPUT 5 or InPUT 6.
Optional modules allow you to increase your total number of inputs and/or accommodate different
signal types, whether analog or digital. install in the areas labeled InPUT 5 or InPUT 6. Options
include:
Serial Digital input module - HD (SDi)•
DVi input module • (standard on XXXX HD models)
Dual SD/HD-SDi module • (standard on XXXX HD models)
nOTe: See Appendix F – Optional Input Modules for a brief description of each interface.
Figure 2.9 Connecting Composite or S-Video sources

Composite and S-Video >

Optional Inputs >

Section2►InstallationandSetup