Wolf Cinema Owner's Manual
3-61
When the projector encounters a system malfunction, either a System Warning message
or a System error message may appear. Both types of messages are accompanied by
a numerical error code on the status leD display. a system malfunction can be cleared
with exit exit from presentation level, but may indicate the need for service by a
qualiedservicetechnician.
nOTe: System messages appear on-screen only if Display Error Messages has been
set to “Screen” or “All”.
system Warnings
a system warning indicates that a system malfunction has been detected (see Status
leD Codes, below). a system warning message replaces any input signal message
and disappears when the input signal status changes. While the projector will remain
operational, the message indicates the presence of a potentially serious problem that
should be investigated. you can press exit exit to remove the message, but for best
results you should reset the projector — power the projector down and up again with
the (power) key.
system errors
a system error message indicates that a serious malfunction has been detected and
must be investigated as soon as possible (see Status leD Codes, below). The projector
will no longer operate and must be reset — power the projector down and up again with
the (power) key.
The status leD Codes
if the status code display on the back of the projector shows one of the following values,
youhaveencounteredalikelysystemerrorrequiringtheattentionofaqualiedservice
technician (see System Warnings and System Errors, above). acknowledge and clear the
error with exit exit from presentation level, or try resetting the projector by powering it
off and on again, cooling when necessary. Consult Table 3.5 and contact your dealer if the
problem persists.
Thespeciccodenumberidentiesthesource oftheerrordetected,andisparticularly
useful in cases where the projector is far away. For example, the code “27” means the
lamp could not be turned on. error codes for this projector are listed in Table 3.5 on the
next page.
Section3►Operation
System Warnings / Errors >