Install the Cooktop
COMPLETE THE INSTALLATION
Once the multi-function cooktop has been checked for gas leaks, plug the power cord into the grounded electri- cal outlet. Place the burner head on the burner base and position the burner grate over the burner assembly.
Read the entire Wolf multi-function cooktop use & care guide included with the unit. It contains important safety, operation, service and warranty information.
Before operating, clean the multi-function cooktop thor- oughly with hot water and a mild detergent. Rinse and dry with a soft cloth. This removes any residual oil and grease left on the surface from the manufacturing process. Refer to care recommendations in the use & care guide.
VERIFY OPERATION
The burner of the gas multi-function cooktop uses an electronic igniter in place of a standing pilot. When the control knob is pushed in and turned to the HIGH position, the system creates a spark to light the burner. This sparking continues until the electronic ignition senses a flame.
To check operation of the burner, push in and turn the control knob to the HIGH position. The flame should light within four seconds.
If the burner does not light properly, turn the control knob to the OFF position. Check that the burner head is in the proper position. Make sure the power cord is plugged in and the circuit breaker or house fuse has not blown. Check that the gas shut-off valve is in the open position. Check operation again; if the burner does not light properly at this point, contact Wolf factory certified service.
IMPORTANT NOTE: Initial lighting of the burner may take slightly longer as air in the system must be purged before gas can be supplied to the burner.
