Install the Cooktop
Remove the multi-function cooktop and gas pressure regulator from its shipping carton and discard packing materials.
Lower the multi-function cooktop into the countertop cut-out opening. Center the cooktop in the opening and check that the front edge of cooktop is parallel to the front edge of the countertop. Check that all required clearances are met. Using a pencil, outline the rear edge of the cooktop frame on the countertop. Remove the cooktop from the countertop opening.
IMPORTANT NOTE: When repositioning the multi-function cooktop in the countertop opening, lift the entire cooktop up from the opening to prevent scratching the countertop.
Apply the foam strip, included in the hardware package, to the underside of the multi-function cooktop frame. Refer to the illustration below.
Reinsert the multi-function cooktop into the countertop opening. Align the rear edge of the cooktop frame with the pencil line and check that it is parallel to the front edge of the countertop. Lift the entire cooktop to make adjust- ments.
Attach the brackets to the burner box by inserting the clips into the rectangular punchouts on the left and right side of the burner box. Insert the 31/2" (89) clamping screws into the brackets. Use a screwdriver to tighten the clamping screws against the underside of the countertop. Refer to the illustration below. Do not overtighten screws.
IMPORTANT NOTE: Do not seal the cooktop to the coun- tertop. It must be removed if service is necessary.
