Woods Equipment BB48X, BB84X, BB60X, BB72X manual 36Assembly, Dealer Set-Upinstructions

ASSEMBLY

DEALER SET-UP INSTRUCTIONS

Assembly of this cutter is the responsibility of the Woods dealer. It should be delivered to the owner com- pletely assembled, lubricated, and adjusted for normal cutting conditions.

The cutter is shipped partially assembled. Assembly will be easier if aligned and loosely assembled before tightening hardware. Recommended torque values for hardware are located in the Bolt Torque Chart, page 56.

Complete Dealer Check Lists, page 34 when you have completed the assembly.

be stopped when anyone comes within 300 feet (92 m).

•This shielding is designed to reduce the risk of thrown objects. The mower deck and protec- tive devices cannot prevent all objects from escaping the blade enclosure in every mowing condition. It is possible for objects to ricochet and escape, traveling as much as 300 feet (92 m).

Make sure attachment is properly secured, adjusted, and in good operating condition.

CAUTION

Full chain, rubber, or steel band shielding must be installed when operating in populated areas or other areas where thrown objects could injure peo- ple or damage property.

•If this machine is not equipped with full chain, rubber, or steel band shielding, operation must

Always wear relatively tight and belted clothing to avoid getting caught in moving parts. Wear sturdy, rough-soled work shoes and protective equipment for eyes, hair, hands, hearing, and head; and respirator or filter mask where appropriate.

1.Mounting pin hardware

2.A-Frame bar

3.Upper mounting hardware (under clutch shield)

4.Diagonal brace

5A. Diagonal brace bar

mounting hole

5B. Tailwheel pivot hole

6.Tailwheel bracket

7.PTO Hanger

9.Tailwheel

10.Height adjustment

12.Bag of hardware

13.Driveline (Shear bolt)

14.Clutch shield

	2	6
	14	3
	4
9		10
7		5B
		5A
1
	13

Figure 30. BB48X Shipping Configuration

36Assembly

(Rev. 4/24/2009) MAN0632 (5/15/2007)