INSTALL TAILWHEEL
1.Attach tailwheel bracket (6) to cutter at the tailwheel pivot holes (5B) using cap screw (13) and flange lock nut (14) previously removed.
NOTE: Make sure grease fitting on tube is on top when installing tailwheel.
2.Select desired height adjustment holes (10), and secure tailwheel bracket with cap screws (13) and flange lock nuts (14). Cutting height adjustment will be necessary when cutter is fully assembled. See page 16.
3.Raise rear of cutter and insert tailwheel assembly
(9)into tailwheel bracket (6). Secure with washer
(37)and spiral pin (28).
4.Place diagonal brace bars (4) on the inside of frame rails and attach to diagonal brace mounting holes (5A). Secure using cap screws (13) and flange lock nuts (14).
|
|
|
|
|
|
| 4. | Diagonal brace bar | 10. | Cutting height |
|
| 5A. | Diagonal brace |
| bracket |
|
|
| mounting hole | 13. | 5/8 NC x 2 HHCS |
|
| 5B. | Tailwheel pivot hole | 14. | 5/8 NC Flange nut |
|
| 6. | Tailwheel bracket | 28. | Spirol pin |
|
| 9. | Tailwheel assembly | 37. | 33 mm Flat washer |
|
|
|
|
|
|
|
|
|
|
|
|
|
Figure 35. Tailwheel Installation
INSTALL DUAL TAILWHEEL
BB84XD (OPTIONAL)
1.Attach dual tailwheel (1) to main frame (2) using position 5B and desired height adjustment holes as shown in Figure 36.
2.Secure with cap screws (3) and hex nuts (4).
3.Torque hardware to 175
1. Dual tailwheel
2. Deck, BB84XD
3. 5/8 NC x
4. 5/8 Flange lock nut
Figure 36. Dual Tailwheel Installation
BB48X Standard Hitch Set-Up
1.Remove cap screw (18), upper Figure 34, and flange lock nut (20) from top hole on
2.Position diagonal brace bars (7) on the outside of
3.Align diagonal brace bars with top hole in
BB48X Quick Hitch Set-Up
An optional Quick Hitch attachment may be used on this cutter. Install
(Rev. 5/10/2009) MAN0632 (5/15/2007)
