Install CV Drive (BW180HD)- Optional
Before installing cutter input driveline to gearbox, check the tag wired to the driveline and the tag wired to the input shaft of gearbox. Ensure the tag rpm speeds match the rpm speed decal on front of cutter. After con- firming all speeds match, remove and discard tags and then complete driveline assembly.
1.Align hole in drive yoke with groove on gearbox input shaft and slide rear half of drive (23) onto shaft.
2.Secure with bolt and nut supplied with drive.
23.CV Drive
Figure 29. CV Drive Installation
Install Wing (BW180HD)
CAUTION
Use a suitable lifting device of sufficient capac- ity. Use adequate personnel to handle heavy com- ponents.
7.Side skid 15.Hinge pin
35. 1" Flat washer
37. Spring pin, 1/4 x
55. 1/2 NC Lock nut
56. 1/2 NC x
Figure 30. Right Wing Installation
Install Wing Cylinder & Lock-up Bar (BW180HD)
The wing must be installed in the following sequence and will require at least two people. A floor jack or a suitable lifting device will be helpful to align decks when installing the hinge pin.
Check RPM tags on wing and center section to make sure they match before proceeding.
1. | Remove hinge pin (15) from center section. |
2. | Place wing assembly adjacent to the center section |
| and align hinge sections. |
3. | Insert hinge pin through the hinge sections and |
| secure with spring pin (67) and washer (35) on |
4.Hydraulic cylinder
17. Spacer, 1"
18. 1 x 2.72 Clevis pin
19. Wing
22. 1" x 4.08" Clevis pin
23. Cylinder link
24. Cylinder link
25. Spacer, 3/4
26.
27. Washer, 1 x
40.1/2 NPT x 1/4 NPT Reducer bushing
41.1/4 NPT x 1/4 NPT Restricted
42.1/4 NPT x 1/4 NPT x 200" Hose
45. 3/16 Safety pin
66. 1/4 x
| both ends. |
4. | Attach side skid (7) to the wing using four carriage |
| bolts (56) and flange lock nuts (55). |
5. | Repeat procedure of opposite wing. |
Figure 31. Wing Cylinder &
1.Place two cylinder links (23 & 24) on either side of cylinder lug on center section as shown, align holes and insert clevis pin (22).
MAN0805 (4/30/2009) | Assembly 37 |
|
|