Install 3-Joint Drive - 540 RPM Only (BW180HD)
Before installing cutter input driveline to gearbox, check the tag wired to the driveline and the tag wired to the input shaft of gearbox. Ensure the tag rpm speeds match the rpm speed decal on front of cutter. After con- firming all speeds match, remove and discard tags and then complete driveline assembly.
1.Attach
4.Secure with bolt and nut supplied with drive.
5.Secure driveline carrier bearing to
NOTE: When cutting height is established, adjust the
6.Attach front driveline (28) to rear driveline (29) and tighten clamp bolt and nut.
2.Coat splined end of gearbox input shaft with grease.
3.Align hole in drive yoke with groove on gearbox input shaft and slide drive (29) onto shaft.
7.Attach shield (19) to driveline carrier bearing with two cap screws (57) and lock washers (58).
8.Attach spacer (54) and hydraulic hose holder (27) to top hole of
19.Carrier bearing shield
24.Tongue
26.
27.Hydraulic hose holder
28.Front half,
29.Rear half, Telescoping driveshaft
45.5/8" NC x 7" HHCS GR5
46.5/8" x
47.5/8" x 1" x 9/16" Sleeve, HT
48.5/8" NC Lock nut
50.1/2" NC x
53.1/2" Flat washer
54.1/2" x 4.56" Spacer, pipe schedule 40 55.1/2" NC Flanged lock nut
56.Sleeve, .50" x 1.00" x 1.031"
57.3/8" NC x 1" HHCS GR5
58.3/8" Lock washer
Figure 28.
36 Assembly | MAN0805 (4/30/2009) |
|
|