Woods Equipment BW180HDQ, BW180HB manual Assembly, Install Wing Wheel and Hub All Models

NOTE: Items 23 & 24 must be installed with square corners on top and facing cylinder as shown.

2.Slide spacer (17) and lock-up bar (19) over clevis pin (22) on back side of cylinder lug & secure with washer (27) and cotter pins (66).

3.Attach base end of wing cylinder (4) to cylinder links (23 & 24) using clevis pin (18) and cotter pins (66).

4.Remove plug from base end of hydraulic cylinder. Align cylinder rod end with cylinder lug on the wing and insert lock-up pin (26).

5.Slide spacer (25) over lock-up pin (26) on back side of cylinder rod and secure with cotter pins (66).

6.Insert safety pin (45) into the end of lock-up pin (26). The safety pin will secure lock-up bar into position when wing is in the UP position.

7.Extend cylinder fully & replace plug in base end of cylinder. This trapped air will help push wing down.

8.Install bushing (40), elbow, (41) and hose (42) to the rod end of cylinder (4). See Install Hose Kit (BW180HD), page 39 for complete instructions.

9.Repeat procedure for opposite wing.

23

24

19

			22
			66
	17
			DP3
17.	Spacer, 1"	23.	Cylinder link
19.	Wing lock-up bar	24.	Cylinder link
22.	Headless pin,	66.	Cotter pin,
	1 x 4.08		1/4 x 1-1/2

Figure 32. Left Wing Lock-Up Bar Installed

Install Wing Wheel and Hub (All Models)

1.Insert wheel hub into wing wheel yoke arms (6) and align holes.

2.Secure into position using cap screw (54) and flanged lock nut (55).

3.Attach wheel to hub using five lug nuts. Install the chamfered side of the lug nut toward the inside for steel rim for pneumatic tires and rims. Tighten to 75 lbs-ft. Check that tire air pressure is a maximum of 40 psi.

NOTE: Install the flat side of the nut toward the inside for solid tires and aircraft tires (shown).

4.Install optional dual wheel and hub to inside of wheel yoke arm.

NOTE: Pneumatic (BW180HD models and BW180HB models), notat, and airplane tires are available for this cutter. See page 63 for parts list.

6.Wing wheel yoke arm, right

21. Wheel and hub

39.1/2 NC x 3 HHCS GR5

40.1/2 NC Flanged lock nut

Figure 33. Wing Wheel and Hub Installation - Right

38 Assembly MAN0805 (4/30/2009)