Woods Equipment BW180HD Dealer Check Lists, Notice, Pre-Deliverycheck List, Delivery Check List

DEALER CHECK LISTS

PRE-DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

Inspect the equipment thoroughly after assembly to ensure it is set up properly before delivering it to the customer.

The following check lists are a reminder of points to inspect. Check off each item as it is found satisfactory or after proper adjustment is made.

NOTICE

■Gearboxes are not filled at the factory. Prior to delivery, make sure each gearbox is filled between lowest ring and end of dipstick with 80 or 90W API GL-4 or GL-5 gear lube.

___ Check that all safety decals are installed and in good condition. Replace if damaged.

___ Check that shields and guards are properly installed and in good condition. Replace if dam-

	aged.
___	Check all bolts to be sure they are properly
	torqued.
___	Check wheel bolts for proper torque.
___	Check that all cotter pins and safety pins are
	properly installed. Replace if damaged.
___	Check that blades have been properly installed.
___	Check and grease all lubrication points as identi-
	fied in lubrication information on page 20.
___	Check the level of gearbox fluids before delivery.
	Service, if required, as specified in the lubrication
	information on page 20.

DELIVERY CHECK LIST

(DEALER’S RESPONSIBILITY)

___ Show customer how to make adjustments and select proper PTO speed.

___ Show customer how to make sure driveline is properly installed and that spring-activated lock- ing pin or collar slides freely and is seated in groove on tractor PTO shaft.

___	Show customer how to determine the turning lim-
	its of the CV PTO driveline.
___	Show customer the safe, proper procedures to be
	used when mounting, dismounting, and storing
	equipment.
___	Make customer aware of optional equipment
	available so that customer can make proper
	choices as required.
___	Instruct customer how to lubricate and explain
	importance of lubrication.
___	Point out the safety decals. Explain their meaning
	and the need to keep them in place and in good
	condition. Emphasize the increased safety haz-
	ards when instructions are not followed.
___	Explain to customer that when transporting the
	cutter, the wing and center sections should be
	raised and their respective transport bars
	installed and pinned in place.
___	Present Operator's Manual and request that cus-
	tomer and all operators read it before operating
	equipment. Point out the manual safety rules,
	explain their meanings and emphasize the
	increased safety hazards that exist when safety
	rules are not followed.
___	Explain to customer the potential crushing haz-
	ards of going underneath raised equipment.
	Instruct that before going underneath to discon-
	nect the driveline, securely block up all corners
	with jack stands and to follow all instructions in
	the BLOCKING METHOD, page 19 of the opera-
	tor’s manual. Explain that blocking up prevents
	equipment dropping from hydraulic leak down,
	hydraulic system failures or mechanical compo-
	nent failures.
___	Point out all guards and shields. Explain their
	importance and the safety hazards that exist
	when not kept in place and in good condition.
___	Explain to customer that when towing on a public
	road to comply with all state and local light-
	ing/marking laws and to use a safety tow chain.

MAN0805 (4/30/2009) Dealer Check Lists 43