Woodstock M1113 owner manual Assembly, To assemble the bandsaw, do these steps

M1113 18" Wood/Metal Bandsaw

SETUP

Assembly

To assemble the bandsaw, do these steps:

1.Place the bandsaw table upside down on a flat sur- face (preferably a workbench) and make sure the table trunnion mounting bolts (Figure 9) are tight.

2.Attach the table extension to the table with the two 5⁄16-18 x 2" hex bolts, two 5⁄16-18 hex nuts, and four 5⁄16" flat washers, as shown in Figure 10. Make sure that the table and table extension are firmly pressed against the flat surface and tighten the bolts/nuts.

3.Remove the table pin from the table slot, fit the table around the blade, and rest the table trunnions on the trunnion base, making sure the trunnion bolts extend through the bottom of the trunnion base.

Table Trunnion

Mounting Bolts

Figure 9. Table trunnion mounting bolts.

Table Extension

4.Thread the two table trunnion knobs onto the trun- nion bolts, as illustrated in Figure 11.

5.Adjust the table stop bolt (Figure 12) so the table is approximately perpendicular to the blade. (Precise adjustment of the table stop bolt will be covered later.)

6.Place the table insert in the center of the table, so it sits flush with the table top surface.

7.Insert the table pin into the end of the table slot.

Figure 10. Table extension attached to

table on flat surface.

�����

�����

��������

��������

����

�������������

�������������

Figure 11. Installing the table on trunnion

base.

Table Stop

Bolt

-14- Figure 12. Table stop bolt.