Installing fence onto rails | Woodstock M1113 specification

M1113 18" Wood/Metal Bandsaw

8. Attach the rear fence rail to the backside of the bandsaw table with two M6-1 x 6 cap screws, as shown in Figure 13.

Figure 13. Rear fence rail attached to

table.

9.Attach the rail brackets to the front of the table with the two M6-1 x 16 cap screws, as shown in

Figure 14.

Rail

Brackets

Figure 14. Rail brackets attached to table.

10.Insert the rail bracket knobs through the front fence rail brackets, then thread the T-nuts onto the ends of the knobs a couple of turns.

11.Slide the front fence rail T-slot over the T-nuts, as

shown in Figure 15, then position the front fence rail brackets even with the rear fence rail, and tighten the knobs.

Rail Bracket Knobs

Figure 15. Front fence rail attached.

12.Pull the fence handle up and place the fence on the front fence rail, as shown in Figure 16.

13.Slide the fence against the blade.

Figure 16. Installing fence onto rails.

-15-

SETUP

Image 17

Woodstock M1113 owner manual Installing fence onto rails

Contents

WOOD/METAL Bandsaw Page Contents Woodstock Technical Support Introduction Introduction Introduction Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Bandsaws Electrical Electrical Specifications220V Operation Extension Cords Main Components Figure Qty SetupInventory Cleaning Machine Machine Placement To lift and move the bandsaw with a forklift, do these steps Lifting & Moving Bolting to Concrete Floors Mounting to Shop Floor To assemble the bandsaw, do these steps Assembly Installing fence onto rails Recommended CFM at each Dust Port Dust Collection To center track the blade Blade Tracking To test run the machine, do these steps Test Run To tension the bandsaw blade Blade Tensioning Support Bearing AdjustmentTo adjust the support bearings, do these steps To adjust the upper and lower blade guides, do these steps Blade Guide Adjustment Table Tilt Scale Calibration Table Stop Adjustment Fence Alignment Table Alignment Basic Controls OperationsGeneral Choosing wood without embedded foreign objects embedded Workpiece Inspection Wood Workpiece Inspection Metal Basic Cutting Tips Cutting OverviewTable Tilt To make a rip cut, do these steps Guide PostRip Cutting Resawing CrosscuttingTo make a 90˚ crosscut, do these steps To resaw a workpiece, do these steps To complete a stacked cut, do these steps Cutting CurvesStacked Cuts Blade Length Blade Characteristics Wood CuttingBlade Width Tooth Style Blade Care Tooth PitchBlade Breakage Most common causes of blade breakage are To select the correct blade TPI, do these steps Blade Selection Metal Cutting To replace the blade, do these steps Blade Changes To calibrate the scale, do these steps Fence Scale Calibration Model D3122 Shop Fox Push Stick AccessoriesModel D3096 Shop Fox Featherboard Cleaning MaintenanceSchedule Table & Base Accessing V-Belts ServiceServicing V-Belts Checking V-Belts Step Follow all previous instructions for Accessing V- BeltsTensioning/Replacing V-Belts To shim the table, do these steps Shimming TableBlade Lead To skew your fence, do these steps Shimming Upper Wheel Wheel AlignmentVerifying Upper/Lower Wheels are Coplanar To adjust the lower wheel, do these steps Adjusting Lower Wheel Motor junction box wiring Electrical Component Wiring Wiring Diagram Motor & Electrical Troubleshooting Miscellaneous Cutting Operations Wood/Metal Bandsaw PART# Description Bandsaw Body Parts List Table & Guides Breakdown Table & Guides Parts List Fence Breakdown Label Placement M1113 18 Wood/Metal Bandsaw Comments Warranty Registration BOX BELLINGHAM, WA