M1113 18" Wood/Metal Bandsaw
Test Run
SETUP
Once the assembly is complete, test run the machine to make sure it runs properly for regular operations.
The test run consists of verifying the following: 1) The motor powers up and runs correctly, and 2) the safety dis- abling mechanism on the switch works correctly.
If, during the test run, you cannot easily locate the source of an unusual noise or vibration, stop using the machine immediately, then review Troubleshooting on Page 46.
If you still cannot remedy a problem, contact our Tech Support at (360)
To test run the machine, do these steps:
1.Connect the machine to the power source.
2.Make sure you understand the safety instructions at the beginning of the manual, and verify that the machine is setup properly.
3.Ensure all tools and objects used during setup are cleared away from the machine.
4.Press the green ON button on the power switch, then press the ON key on the motor switch to start the machine.
—When operating correctly, the machine runs smoothly with little or vibration or rubbing noise.
—Investigate and correct strange noises or vibrations before operating the machine further. Always dis- connect the machine from power when investigat- ing or correcting potential problems.
5.Turn the machine OFF.
6.Insert the switch disabling pin through the green ON button, as shown in Figure 22.
7.Press the ON button to test the disabling feature on the switch.
—If the machine does not start, the switch disabling feature is working as designed.
—If the machine starts, immediately stop the machine or disconnect the power. The switch dis- abling feature is not working correctly. Call Tech Support for help.
Projectiles thrown from the machine could cause serious eye injury. Wear safety glasses to reduce the risk of injury.
DO NOT investigate problems or adjust the machine while it is running. Wait until the machine is turned OFF, unplugged and all working parts have come to a complete stop before proceeding!
Switch
Disabling Pin
