M1113 18" Wood/Metal Bandsaw
OPERATIONS
OPERATIONS
General
This machine will perform many types of operations that are beyond the scope of this manual. Many of these operations can be dangerous or deadly if performed incor- rectly.
The instructions in this section are written with the under- standing that the operator has the necessary knowledge and skills to operate this machine. If at any time you are experiencing difficulties performing any operation, stop using the machine!
If you are an inexperienced operator, we strongly recom- mend that you read books, trade articles, or seek training from an experienced bandsaw operator before performing any unfamiliar operations. Above all, your safety should come first!
Basic Controls
Motor Switch: Starts and stops the motor. Only works after the power switch has been reset and turned ON.
Speed Dial: Adjusts the speed of the motor, which is dis- played in RPM on the digital display.
Power Switch: Turns power ON/OFF to the motor switch. OFF button must be reset (by pushing it all the way in) before power will turn ON again.
Blade Tension Lever: Increases/decreases blade tension when rotated. Quickly releases blade tension when piv- oted up.
Blade Guide Elevation Handwheel: Raises/lowers the upper blade guide assembly when rotated. The blade guide assembly should always be no farther than 1" above the workpiece when cutting.
READ and understand this entire instruc- tion manual before using this machine. Serious personal injury may occur if safety and operational information is not understood and followed. DO NOT risk your safety by not reading!
Motor
Switch
Digital
Display
Speed Dial
Power
Switch
Figure 34. Motor, speed, and power
controls.
Blade Tension
Lever
Blade Guide
Elevation
Handwheel
Blade Guide
Assembly