Base and Column, Dust Port | Woodstock W1667 instruction

Base and Column

The base and column must be securely mount- ed, so if drilling an odd-shaped workpiece the machine will not fall over.

To install the base and column, do these steps:

1.Position the drill press base on a flat and stable surface.

2.Using two clamps, clamp the base to the mounting surface.

3.Use the holes provided in the bottom of the base as a drill guide, and drill holes in the mounting surface. See Figure 7.

4.Secure the base using 5⁄16" lag bolts or sup- plied through bolts with washers and nuts.

5.Place the column on the base, line up the 3 mounting holes, and secure tightly with the three M8-1.25 x 16mm hex head bolts using the open-end wrench provided.

Dust Port

The dust port directs suction to the sanding sleeve, removing hazardous dust and increasing abrasive life.

To install the dust port, do these steps:

1.Position the two-piece dust port to the bottom of the table. See Figure 8.

2.Insert the four M4-0.7 x 22mm Phillips head screws and tighten.

Figure 7. Using holes as a drill guide.

ASSEMBLY

Figure 8. Installing the dust port.

-9-

Image 11

Woodstock W1667 instruction manual Base and Column, Dust Port, To install the base and column, do these steps

Contents

81⁄2 Oscillating Drill Press Page Contents About Your W1667 8 1⁄2 Oscillating Drill Press Woodstock Service and Support Specifications Warranty and Returns Disconnect machine when cleaning, adjusting or servicing Standard Safety Instructions Keep proper footing and balance at all times Additional Safety Instructions for Drill Presses Never drill while holding Workpiece by hand Avoiding Potential Injuries Extension Cords 110V OperationGrounding Box Contents Assembly Dust Port To install the base and column, do these stepsTo install the dust port, do these steps Base and Column Loosely installing table lock lever To install the table, do these steps Aligning the pocket in the headstock With the column Headstock Handles To install the drill chuck, do these stepsTo install the handles, do these steps Drill Chuck Belt Tension To adjust the drive belt tension, do these steps Feed Shaft Spring Tension To adjust the feed shaft spring tension, do these steps Hold the spring cover tightly Quill-Shaft Screw Support table while loosening lock Table Height / Tilt Loosening the lock knob Drilling Speed Drilling Depth Drill Press RPM ChartTo adjust the drilling depth, do these steps Adjustments Adjustments Starting the Drill Press Operations To change drill bits and sanding drums, do these steps Drill/Drum Changes Remove the spindle handles Using the OscillatorTo use the oscillating feature, do these steps Sanding drum installed Sanding Sleeves GeneralTable and Base Lubrication Troubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA