Woodstock W1667 Drill Chuck, Handles, To install the drill chuck, do these steps

ASSEMBLY

Drill Chuck

The drill chuck is seated to the spindle with a JT-33 tapered surface and a screw.

To install the drill chuck, do these steps:

1.Clean the drill chuck and spindle with min- eral spirits and follow all safety warnings on the container. Failure to clean the tapered-mating surfaces of the spindle and drill chuck will result in the chuck falling off during use.

2.Use the provided chuck key to adjust the jaws of the chuck until they are well inside the drill chuck body. See Figure 12.

NOTICE

DO NOT use a hammer to seat the drill chuck onto the spindle. You will damage the oscillating mechanism.

3.Place the drill chuck on the spindle, and insert the cap screw into the hole of the drill chuck. See Figure 13.

4.Tighten the cap screw so the drill chuck is seated securely on the spindle.

•If the chuck fails to remain secure on the spindle, repeat Step 1, DO NOT use a hammer to seat the drill chuck onto the spindle!

Handles

Three handles are supplied for drilling opera- tions. NOTE: remove these handles when you use the oscillating feature.

To install the handles, do these steps:

1.Thread the handles into the hub as shown in Figure 14.

2.Tighten the handles until they are snug, DO NOT over-tighten.

Figure 12. Jaws adjusted inside chuck body.

Figure 13. Inserting the caps crew.

Figure 14. Installing spindle handles.

-12-