Manuals / Woodstock / Power Tools / Drill

Woodstock W1667 instruction manual Contents

Models: W1667

1 36

Download 36 pages 38.74 Kb

Page 3

CONTENTS
INTRODUCTION	2
About Your W1667 8 1⁄2'' Oscillating Drill Press	2
Woodstock Service and Support	2
Warranty and Returns	3
Specifications	3
SAFETY	4
Standard Safety Instructions	4
Additional Safety Instructions for Drill Presses	5
Avoiding Potential Injuries	6
ELECTRICAL	7
110V Operation	7
Grounding	7
Extension Cords	7
ASSEMBLY	8
Box Contents	8
Base and Column	9
Dust Port	9
Table	10
Headstock	11
Drill Chuck	12
Handles	12
ADJUSTMENTS	13
Belt Tension	13
Feed Shaft Spring Tension	14
Quill-Shaft Screw	15
Table Height / Tilt	16
Drilling Speed	17
Drill Press RPM Chart	18
Drilling Depth	18
Drill, Cutter, and Hole Saw Suggested RPM Chart	19
OPERATIONS	21
Starting the Drill Press	21
Drill/Drum Changes	22
Using the Oscillator	23
MAINTENANCE	25
General	25
Lubrication	25
Table and Base	25
Sanding Sleeves	25
Troubleshooting	26
Parts Diagram	27
Parts List	28
Drill Press Accessories	29

-1-

INTRODUCTION SAFETY

ELECTRICAL

ASSEMBLY ADJUSTMENTS OPERATIONS MAINTENANCE

Image 3

Woodstock W1667 instruction manual Contents

Contents

81⁄2 Oscillating Drill Press Page Contents About Your W1667 8 1⁄2 Oscillating Drill Press Woodstock Service and SupportSpecifications Warranty and ReturnsDisconnect machine when cleaning, adjusting or servicing Standard Safety InstructionsKeep proper footing and balance at all times Additional Safety Instructions for Drill PressesNever drill while holding Workpiece by hand Avoiding Potential Injuries110V Operation GroundingExtension Cords Box Contents AssemblyDust Port To install the base and column, do these stepsTo install the dust port, do these steps Base and ColumnLoosely installing table lock lever To install the table, do these stepsAligning the pocket in the headstock With the column HeadstockHandles To install the drill chuck, do these stepsTo install the handles, do these steps Drill ChuckBelt Tension To adjust the drive belt tension, do these stepsFeed Shaft Spring Tension To adjust the feed shaft spring tension, do these stepsHold the spring cover tightly Quill-Shaft ScrewSupport table while loosening lock Table Height / TiltLoosening the lock knob Drilling SpeedDrill Press RPM Chart To adjust the drilling depth, do these stepsDrilling Depth Adjustments Adjustments Starting the Drill Press OperationsTo change drill bits and sanding drums, do these steps Drill/Drum ChangesUsing the Oscillator To use the oscillating feature, do these stepsRemove the spindle handles Sanding drum installed Sanding Sleeves GeneralTable and Base LubricationTroubleshooting Parts Diagram Parts List Drill Press Accessories Drill Press Accessories Warranty Card BOX BELLINGHAM, WA