ADJUSTMENTS

Feed Shaft Spring

Tension

The feed shaft return spring is adjusted at the fac- tory; however, during the life of the drill press you may want to adjust the feed shaft return spring at a stronger return pressure.

MAKE SURE your machine is unplugged during all assembly, adjustments, or maintenance procedures. Otherwise serious personal injury may occur!

WEAR safety glasses when adjusting springs. Serious injury may occur if this warning is ignored!

To adjust the feed shaft spring tension, do these steps:

1.UNPLUG THE DRILL PRESS!

2.Wipe off any oil on the spring lock cover so it will not slip in your fingers when you hold the cover from spinning. See Figure 18.

3.Make sure the quill shaft is completely seat- ed and the depth stop reads “0”. See Figure 19.

4.Put on thick leather gloves and hold the spring cover against the side of the head- stock so the cover stays splined with the locking lug; remove the jam nut and loosen the cover nut approximately 14" (6.4mm). See Figure 19.

5.Pull the cover outward just enough to dis- engage the spring-cover lock slot from the locking lug. See Figure 20.

6.Rotate the cover counter clockwise to increase spring tension, or let the cover slowly unwind in the clockwise direction to reduce spring tension. See Figure 20.

Cover Nut

Jam Nut

Spring

Lock Cover

Figure 18. Feed shaft return spring assembly.

Depth Stop

at “0”

Quill Shaft

Fully

Seated

Figure 19. Quill shaft fully seated.

Locking Lug

Spring-Cover

Lock Slot

Figure 20. Typical spring cover lock slot and

locking lug.

-14-

Page 16
Image 16
Woodstock W1667 instruction manual Feed Shaft Spring Tension, To adjust the feed shaft spring tension, do these steps