Fence Assembly | Woodstock W1694 manual

Fence Assembly

The fence assembly consists of the fence, the fence adjusting bracket, and the fence tilting handle.

To assemble the fence assembly, do these steps:

1.Attach the fence to the fence adjusting bracket with four 8mm flat washers and four M8-1.25 x 20 cap screws (Figure 11).

2.Slide the fence assembly over the dovetail way and onto the fence support (Figure 12).

3. Secure the fence assembly to the fence sup- port by tightening the fence sliding handle.

4.Secure the fence position by threading the fence tilting handle through the fence adjusting bracket (Figure 13). Further adjustment of the fence will be discussed in the Adjustments section.

Figure 11. Attaching the fence to the fence

adjusting bracket.

ASSEMBLY

Dovetail Way

Figure 12. Fence assembly on dovetail way.

Fence Tilting

Handle

Figure 13. Securing the fence tilting handle.

-13-

Image 15

Woodstock W1694 instruction manual Fence Assembly, To assemble the fence assembly, do these steps

Contents

Bench TOP Jointer Page Contents Woodstock Service and Support IntroductionAbout Your New Jointer Specifications Warranty and Returns Standard Safety Instructions Safety #16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Never surface plane without push blocks Avoiding Potential Injuries Extension Cords Electrical Requirements110V Operation Grounding Assembly UnpackingInventory Initial Cleaning Shop PreparationDust Collection To attach the fence support, do these steps Rubber FeetFence Support To attach the rubber feet, do these steps To assemble the fence assembly, do these steps Fence Assembly To install the 90˚ stop slide, do these steps 90˚ Stop SlideDust Port Assembling the trash bag support To connect the dust port to a trash bag, do these steps Fence Adjustments Fence Angle Stops Setting the fence to 90˚ To adjust the 45˚ outward angle stop bolt, do these steps To adjust the 45˚ inward angle stop bolt, do these steps To check the cutterhead blade height, do these steps Blade Height Depth Of Cut To adjust the depth of cut Blade guard in use Blade Guard Operations Test RunTo test run the Model W1694, do these steps Correct and incorrect grain Alignment to cutterhead Operation Requirements Surface Planing To perform a surface planing operation, do these stepsOperation Requirements sub-section To perform an edge jointing operation, do these steps Edge Jointing To perform a bevel cutting operation, do these Bevel Cutting Sharpening Blades MaintenanceGeneral Table Surface To replace the cutterhead blades, do these steps Replacing Blades Guard Spring LubricationTo replace a worn out blade guard spring, do these steps Drive Belts Motor BrushesTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA