Fence Angle Stops, Setting the fence to 90˚ | Woodstock W1694

Fence Angle Stops

There are three fence angle stops: 90˚, 45˚ inward, and 45˚ outward. The angle stops allow the fence to be quickly and accurately posi- tioned at various angles.

To adjust the 90˚ angle stop, do these steps:

1.Using a machinist’s square, position the fence 90˚ relative to the table surface (Figure 21).

2.Position the limit plate in the forward slot of the 90˚ slide stop.

3.Loosen the jam nut on the 90˚ stop slide.

4.Using a flat-head screwdriver, adjust the setscrew on the 90˚ stop slide until the peg makes contact with the back of the fence (Figure 22).

5.Retighten the jam nut loosened in step 3.

Figure 21. Setting the fence to 90˚.

Figure 22. Adjusting the 90˚ stop slide.

ADJUSTMENTS

-17-

Image 19

Woodstock W1694 instruction manual Fence Angle Stops, Setting the fence to 90˚

Contents

Bench TOP Jointer Page Contents Introduction Woodstock Service and SupportAbout Your New Jointer Specifications Warranty and Returns Standard Safety Instructions Safety #16 #14 11-12 13-16 #12 17-20 #10 21-30 Know Your Machine Safety Instructions for Your Jointer Never surface plane without push blocks Avoiding Potential Injuries Extension Cords Electrical Requirements110V Operation Grounding Unpacking AssemblyInventory Shop Preparation Initial CleaningDust Collection To attach the fence support, do these steps Rubber FeetFence Support To attach the rubber feet, do these steps To assemble the fence assembly, do these steps Fence Assembly 90˚ Stop Slide To install the 90˚ stop slide, do these stepsDust Port Assembling the trash bag support To connect the dust port to a trash bag, do these steps Fence Adjustments Fence Angle Stops Setting the fence to 90˚ To adjust the 45˚ outward angle stop bolt, do these steps To adjust the 45˚ inward angle stop bolt, do these steps To check the cutterhead blade height, do these steps Blade Height Depth Of Cut To adjust the depth of cut Blade guard in use Blade Guard Test Run OperationsTo test run the Model W1694, do these steps Correct and incorrect grain Alignment to cutterhead Operation Requirements To perform a surface planing operation, do these steps Surface PlaningOperation Requirements sub-section To perform an edge jointing operation, do these steps Edge Jointing To perform a bevel cutting operation, do these Bevel Cutting Sharpening Blades MaintenanceGeneral Table Surface To replace the cutterhead blades, do these steps Replacing Blades Lubrication Guard SpringTo replace a worn out blade guard spring, do these steps Motor Brushes Drive BeltsTo replace the drive belts, do these steps Troubleshooting Chipping occurs on workpiece Closure W1694 Wiring Diagram Parts Fence Page Base with Outfeed Table Warranty Card BOX BELLINGHAM, WA