-9-
W1752 Owner's Manual (Mfg. 1/07+)
SAFETY
13. FACEPLATE TURNING. When faceplate turning, use lathe chisels on the downward spinning side of
the workpiece only.
14. SANDING/POLISHING. Remove the tool rest when performing sanding or polishing operations on the
rotating spindle.
15. MATERIAL REMOVAL RATE. Removing too much material at once may cause workpiece to fly out of
the lathe.
16. REDUCING WORKPIECE VIBRATION. If the workpiece vibrates, immediately turn the lathe OFF.
Check to make sure the workpiece is centered and balanced. Trim excess waste off corners with a
bandsaw or table saw to reduce vibration. Make sure workpiece is securely attached in setup.