Installing/Removing Faceplate | Woodstock W1752 instruction

W1752 Owner's Manual (Mfg. 1/07+)

Installing/Removing

Faceplate

The faceplate can be installed only if the spur center has been removed from the headstock spindle. The knock-out bar is included with the lathe for installing and removing the faceplate.

To install the faceplate, do these steps:

1.Unplug lathe from power!

2.Remove the spur center (see Page 18).

3.Thread the faceplate onto the headstock spindle.

4.Using the knock-out bar, hand tighten the faceplate as shown in Figure 13.

Note: Reverse Steps 3-4to remove the faceplate.

To mount a workpiece to your faceplate, refer to Page 23.

Figure 13. Tightening faceplate.

OPERATIONS

-19-

Image 21

Woodstock W1752 owner manual Installing/Removing Faceplate, To install the faceplate, do these steps

Contents

OWNERS MANUAL Page Contents Woodstock Technical Support Introduction Overall Dimensions MotorElectrical Other Specifications Main Specifications Controls and Features Standard Safety Instructions Safety Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes Safety Electrical Electrical Specifications110V Operation Extension Cords Unpacking SET UPInventory Box Inventory Figure Machine Placement Cleaning Machine To install the tool rest, do these steps Assembly To test run the mini wood lathe, do these steps Test Run General Operations Changing Speeds Adjusting TailstockTo change speeds, do these steps To position the tailstock along the bed, do these steps Installing/Removing Spur Center Adjusting Tool RestTo adjust the tool rest vertically, do these steps To install the spur center, do these steps Installing/Removing Live Center To install the live center, do these stepsTo remove the live center, do these steps Installing/Removing Faceplate To install the faceplate, do these stepsTo mount a workpiece to your faceplate, refer to Gouge Selecting Turning Tools Spindle Turning To set up a spindle turning operation, do these steps Spindle Turning Tips Faceplate Turning To mount your workpiece to the faceplate, do these stepsTo mount your workpiece to a backing block, do these steps Entanglement Hazard Sanding/Finishing Lathe Accessories Accessories Cleaning MaintenanceLubrication Unpainted Cast Iron Troubleshooting Service Constant Paddle Switch Wiring Diagram W1752 Parts REF PART # Description Parts List PART # Description Label PlacementPage Page Page Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools