Label Placement, PART # Description | Woodstock W1752 guide

W1752 Owner's Manual (Mfg. 1/07+)

Label Placement

Safety labels warn about machine hazards and how to prevent machine damage or injury. The owner of this machine MUST maintain the original location and readability of all labels on this machine. If any label is removed or becomes unreadable, REPLACE that label before allowing the machine to enter service again. Contact Woodstock International, Inc. at (360) 734-3482 or www. shopfoxtools.com to order new labels.

88

87

PARTS

89

90

91

92

93

94

95

REF	PART #	DESCRIPTION
87	X1752087	MACHINE ID LABEL
88	X1752088	DISCONNECT POWER-SPINDLE SPEEDS LABEL
89	X1752089	SAFETY GLASSES LABEL 1-1/2" X 2-1/2"
90	X1752090	READ MANUAL LABEL 1-1/2" X 2-1/2"
91	X1752091	ELECTRICITY LABEL
92	X1752092	ENTANGLEMENT HAZARD LABEL
93	X1752093	SHOP FOX LOGO PLATE
94	X1752094	PAINT FOR SHOP FOX MACHINES
95	X1752095	BLACK BASE PAINT

-32-

Image 34

Woodstock W1752 owner manual Label Placement, PART # Description

Contents

OWNERS MANUAL Page Contents Introduction Woodstock Technical Support Motor Overall DimensionsElectrical Main Specifications Other Specifications Controls and Features Safety Standard Safety Instructions Always Lock Mobile Bases if Used Before Operating Machinery Additional Safety for Wood Lathes Safety 110V Operation Electrical SpecificationsElectrical Extension Cords Inventory SET UPUnpacking Box Inventory Figure Machine Placement Cleaning Machine Assembly To install the tool rest, do these steps Test Run To test run the mini wood lathe, do these steps Operations General To change speeds, do these steps Adjusting TailstockChanging Speeds To position the tailstock along the bed, do these steps To adjust the tool rest vertically, do these steps Adjusting Tool RestInstalling/Removing Spur Center To install the spur center, do these steps To install the live center, do these steps Installing/Removing Live CenterTo remove the live center, do these steps To install the faceplate, do these steps Installing/Removing FaceplateTo mount a workpiece to your faceplate, refer to Selecting Turning Tools Gouge To set up a spindle turning operation, do these steps Spindle Turning Spindle Turning Tips To mount your workpiece to the faceplate, do these steps Faceplate TurningTo mount your workpiece to a backing block, do these steps Sanding/Finishing Entanglement Hazard Accessories Lathe Accessories Lubrication MaintenanceCleaning Unpainted Cast Iron Service Troubleshooting Constant Wiring Diagram W1752 Paddle Switch Parts Parts List REF PART # Description Label Placement PART # DescriptionPage Page Page Woodstock international inc. p.o. box Bellingham, Wa Warranty High Quality Machines and Tools