Woodstock W1819/W1820 manual jXn`eFg\iXk`fej, KfYl`ck\Xlo`c`Xip\eZ\#fk\j\jk\gj1

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

KfYl`c[k_\Xlo`c`Xip]\eZ\#[fk_\j\jk\gj1
(% Cut the auxiliary fence board to size. If you are using
hardwood, cut the board oversize, then joint and
plane the board to the correct size to make sure the	=\eZ\
board is square and flat.
	=\eZ\ 9f[p
		8lo`c`Xip
Efk\1Fecplj\]lie`kli\^iX[\gcpnff[fib`ce[i`\[	=XZ`e^
		=\eZ\
_Xi[nff[kfgi\m\eknXig`e^%
)% Unthread the fence face mounting hardware and
remove the fence face from the fence assembly.
*% Place the auxiliary fence next the fence face you
removed in Jk\g(, mark the location of the nine	=`^li\67% Auxiliary fence.
mounting holes on the auxiliary fence, then drill the
holes.

+% Use the mounting hardware that had previously attached the fence face to attach the auxiliary fence. The end result should be similar to =`^li\67.

I\jXn`e^Fg\iXk`fej

The table saw motor is pushed to its limits when resawing. If the motor starts to bog down, slow down your feed rate. Motor overloading and blade wear can be reduced by using a ripping blade. Ripping blades are designed to clear the sawdust quickly.

:fdgfe\ekjE\\[\[]fiI\jXn`e^1
Zero Clearance Insert	1
Ripping Blade 10"	1
Clamps	2
Shop Made Auxiliary Fence	1
Shop Made Resaw Barrier	1
Kfg\i]fidi\jXn`e^fg\iXk`fej#[fk_\j\jk\gj1
(% DISCONNECT THE SAW FROM POWER!
)% Remove the standard table insert and the blade
guard assembly.

*% Install a ripping blade and the riving knife, lower the blade below the table, then install a zero clearance table insert.

Pfl dXp \og\i`\eZ\ b`ZbYXZb [li`e^ k_`j gifZ\[li\% JkXe[ kf k_\ j`[\ f] k_\YcX[\Xe[n\XiX]lcc]XZ\j_`\c[kf gi\m\ek`ealipn_\ei\jXn`e^%

FG<I8K@FEJ

-51-