Woodstock W1819/W1820 manual `k\iXl\8aljkd\ekj, Zb`e&J\kk`e0—Jkfgj, 8aljk`eD`k\i9XiK`ke\jj

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

D`k\i>Xl^\8[aljkd\ekj

The miter gauge can be adjusted so it is perpendicular to the blade and so it is snug in the T-slot.

KffcjE\\[\[	Hkp
90° Square	1
45° Square	1
Hex Wrench 2.5mm	1
Hex Wrench 2mm	1
Hex Wrench 3mm	1
:_\Zb`e^&J\kk`e^0'—Jkfgj
(% DISCONNECT THE SAW FROM POWER!

)% Slide the miter gauge into the T-slot on the table.

*% Loosen the miter gauge lock knob, pull out the positive stop knob, then pivot the miter gauge body to 90° so the stop knob springs into position.

+% Place the 90° square evenly against the face of the miter gauge and the blade, as shown in =`^li\('0.

—If the square touches the miter body and the body of the blade (not the teeth) evenly at the same time, then it is square to the blade and the 90° stop is set correctly. No further adjustments are necessary.

—If the square does not touch the miter body and blade body evenly at the same time, then proceed to Jk\g,.

,% Loosen the button head cap screws on the positive stop knob block (see =`^li\ (('), adjust the miter body until it is flush with the square, then tighten the screws.

-%Loosen the screw on the front of the miter bar, adjust the pointer to 0°, then tighten the screw.

8[aljk`e^D`k\i9XiK`^_ke\jj

The miter bar can be adjusted so it fits more tightly in the miter slot.

To adjust the miter bar tightness, loosen the cap screw on each guide block (see =`^li\(((), adjust the set screws as needed, then tighten the cap screw.

-73-

JhlXi\

9cX[\

D`k\i>Xl^\

=`^li\('0% Checking 90° stop on miter

gauge.

Positive

Stop Knob

Button Head

Cap Screws

=`^li\(('% Screws for adjusting miter

gauge body.

Set Screws

Cap Screws
	Guide
	Block

=`^li\(((% Screws for adjusting miter bar

in miter slot.

J<IM@:<