Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

J<KLG

('% Install the front rail onto the table and extension wings with four M8-1.25 x 40 hex bolts, eight 8mm flat washers, four 8mm lock washers, and four M8-1.25 hex nuts, as shown in =`^li\(-.

Before final tightening, make sure the front rail is set 316" below the beveled edge along the entire length of the table.

((% N(/(0FECP: Install the 62" front rail tube onto the 50" front rail with the three M6-1 x 16 cap screws, 6mm flat washers, and 6mm lock washers, as shown in =`^li\(..

N(/)'FECP1Install the 82" front rail tube onto the 70" front rail with five M6-1 x 16 cap screws, 6mm lock washers, and 6mm flat washers, as shown in

=`^li\(/.

()% Attach the rear rail to the holes on the main table using two M8-1.25 x 30 hex bolts, 8mm lock washers and 8mm flat washers, as shown in =`^li\ (0.

(*% Secure the rear rail to the extension wings with two M8-1.25 x 40 hex bolts, four 8mm flat washers, two 8mm lock washers and two M8-1.25 hex nuts.

-24-

=`^li\(-%Front rail installed (W1819).

Rail Tube

x3

=`^li\(.% Model W1819 tube attached to

front rail.

Rail Tube

x5

=`^li\(/% Model W1820 tube attached to

front rail.

x2

=`^li\(0% Rear rail installed (W1820).

Page 26
Image 26
Woodstock W1819/W1820 manual =`li\