Woodstock W1819/W1820 manual `k\ilkj, `k\i=\eZ, Kfg\ifidXd`k\iZlk#fk\j\jk\gj1

FG<I8K@FEJ

Df[\cN(/(0&N(/)'D]^%J`eZ\()&('

D`k\i:lkj

A miter is an angled crosscut. Miters are usually cut in the same manner as crosscuts, using the miter gauge and a predetermined mark on the workpiece.

Kfg\i]fidXd`k\iZlk#[fk_\j\jk\gj1

(% DISCONNECT THE SAW FROM POWER!

)%	Ensure that the blade guard/spreader is installed.
*%	Determine the angle of your cut. If the angle needs
	to be very precise, use a protractor to set the miter
	gauge to the blade.
+%	Place the face of the miter gauge against the edge
		=`^li\,*% Example of marking miter line.
	of the workpiece and place the bar across the face
	of the workpiece. Use the bar as a guide to mark
	your cut, as shown in =`^li\,*.
,%	Place the miter gauge back into the slot and hold
	the workpiece firm against the miter gauge body.
	Slide the miter gauge near the blade and adjust the
	workpiece so the blade will cut on the waste side of
	the line.
-%	Proceed to make the cut in the same manner as
	described in the :ifjjZlkk`e^ instructions on GX^\
	+(.

D`k\i=\eZ\

The miter fence provides greater workpiece support than the miter gauge alone, especially for longer workpieces.

Simply loosen the lock levers shown in =`^li\,+, slide the miter fence in the needed direction for the cutting operation, then tighten the levers. Make sure the miter fence does not contact the blade guard or blade when moved through its full range of travel.

Miter

Fence

Lock

Levers

=`^li\,+% Miter fence lock levers.

-42-